Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: SonsBikes
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Forum: Tandem Cycling
06-02-21, 08:53 AM
Replies: 17
Views: 3,351
Posted By SWG

Such a great offer!

Such a great offer!
Forum: Tandem Cycling
06-02-21, 08:23 AM
Replies: 17
Views: 3,351
Posted By Monoborracho

https://cimg4.ibsrv.net/gimg/bikeforums.net-vbulle...

https://cimg4.ibsrv.net/gimg/bikeforums.net-vbulletin/320x240/burley_bbs_521f4d85bee28bac6d4885b2ab7e057064f2b287.jpg


FYI
Some years ago our Burley frame cracked at the SoftRide pivot point. I...
Forum: Tandem Cycling
06-02-21, 07:46 AM
Replies: 17
Views: 3,351
Posted By SWG

The 'cuff' keeps the bearings apart from each...

The 'cuff' keeps the bearings apart from each other but it is designed to move. Cuff is aluminum and can't be welded to the spindle and even if you could weld it that isn't a good idea, the unit...
Forum: Tandem Cycling
06-01-21, 02:39 PM
Replies: 17
Views: 3,351
Posted By SWG

I agree with jccaclimber. Sometimes 'close...

I agree with jccaclimber. Sometimes 'close enough' is what is called for, sometimes not. But if all you're are trying to do is make the bike rideable it might be just the right amount of goodness to...
Forum: Tandem Cycling
05-31-21, 05:05 PM
Replies: 17
Views: 3,351
Posted By jccaclimber

I may be erring a bit too far on the "close...

I may be erring a bit too far on the "close enough" side having been aiming for no-cost fixes at the local bike co-op lately, but I'd ride it and see if it happens again. While that particular...
Forum: Tandem Cycling
05-31-21, 12:51 PM
Replies: 17
Views: 3,351
Posted By Rick

OP means original poster on a forum. The...

OP means original poster on a forum. The eccentric is that round chunk of aluminum with the offset round hole in it. My Burly Bongo uses the same size eccentric as your Burley Duet. Eccentrics are...
Forum: Tandem Cycling
05-31-21, 12:19 PM
Replies: 17
Views: 3,351
Posted By SWG

OP means 'Original Poster', or Thread Starter....

OP means 'Original Poster', or Thread Starter. (in this case you, SonsBikes)
Forum: Tandem Cycling
05-31-21, 08:17 AM
Replies: 17
Views: 3,351
Posted By SWG

What I was attempting to say was that even though...

What I was attempting to say was that even though the spindle has moved, it may not be terminal. Depending on what SonsBikes is trying to do. I agree that ideally a new spindle is optimal, new...
Forum: Tandem Cycling
05-30-21, 08:24 PM
Replies: 17
Views: 3,351
Posted By Rick

You can see from the picture the whole unit is...

You can see from the picture the whole unit is held in by the snap rings. Yes he would need to remove the snap rings and press out the unit. I believe the once tight fit between the spindle and...
Forum: Tandem Cycling
05-30-21, 06:37 PM
Replies: 17
Views: 3,351
Posted By SWG

I have a Duet and although I haven't owned it a...

I have a Duet and although I haven't owned it a long time I have just recently service the BB's. The spindle is a press fit in the bearings. There is a spacer inside but there are no 'stops' on the...
Forum: Tandem Cycling
05-29-21, 06:05 PM
Replies: 17
Views: 3,351
Posted By Rick

I have a 1990 Burley Bongo. Your rear BB when new...

I have a 1990 Burley Bongo. Your rear BB when new was put in with a friction fit and held there by snap ring clips. There was also some what looked like epoxy. I suggest you clean it up as best as...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.