Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: trikeBoomer
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Forum: Bicycle Mechanics
10-06-21, 02:23 AM
Replies: 9
Views: 3,806
Posted By JoeTBM

If it were me, I wouldn't be too concerned with...

If it were me, I wouldn't be too concerned with it, the set screw collar is only there to prevent the axle from drifting. Again, this is not a high quality trike with good quality control, it is what...
Forum: Bicycle Mechanics
10-02-21, 04:13 AM
Replies: 9
Views: 3,806
Posted By JoeTBM

The quality control factor is lacking on these...

The quality control factor is lacking on these trikes, I have assembled quite a few. The last one came with 2 drive rear wheel (right side)and had to wait 2 weeks to get the replacement left wheel.
Forum: Bicycle Mechanics
10-01-21, 06:32 PM
Replies: 9
Views: 3,806
Posted By rickpaulos

Once you get the axle bearing issue sorted out,...

Once you get the axle bearing issue sorted out, next up is the drive wheel vs axle interface. On some of the Schwinn three wheeler models it's far too small of a contact area and prone to striping...
Forum: Introductions
09-21-21, 11:37 AM
Replies: 3
Views: 315
Posted By Hal_Incandenza

Welcome, fellow former lurker!

Welcome, fellow former lurker!
Forum: Bicycle Mechanics
09-19-21, 07:52 AM
Replies: 9
Views: 3,806
Posted By andrewclaus

It appears the 6003RS bearings are radial contact...

It appears the 6003RS bearings are radial contact type and should not be preloaded like angular contact bearings would be.

They should spin smoothly when new, unless poorly made. And they may be...
Forum: Introductions
09-19-21, 05:35 AM
Replies: 3
Views: 315
Posted By rumrunn6

good! welcome!

good! welcome!
Forum: Introductions
09-19-21, 04:47 AM
Replies: 3
Views: 315
Posted By cb400bill

Welcome!

Welcome!
Forum: Bicycle Mechanics
09-19-21, 12:54 AM
Replies: 100
Views: 6,502
Posted By cyrano138

I haven't had time to get into it yet but I...

I haven't had time to get into it yet but I bought two gal off OMS at Lowe's for 25 bucks.
Forum: Bicycle Mechanics
11-04-09, 11:26 AM
Replies: 15
Views: 15,060
Posted By BCRider

Since this is apparently a solid axle the usual...

Since this is apparently a solid axle the usual rules given for tensioning the bearing of hollow axles that were given above do not apply. Being a solid axle you do NOT want any play in the...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.