Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Andrew R Stewart
Showing results 1 to 4 of 4
Search took 0.02 seconds.
Forum: Framebuilders
04-20-21, 09:06 AM
Replies: 21
Views: 1,928
Posted By Andrew R Stewart

The erector set style of crimping tool is made of...

The erector set style of crimping tool is made of plate steel, hand filed/ground steel form and all thread rods with other bits that should be obvious. The plate is about 3/8" thick, I went to a...
Forum: Framebuilders
04-19-21, 08:25 PM
Replies: 21
Views: 1,928
Posted By Andrew R Stewart

Ask and you shall see:) Here's three different...

Ask and you shall see:) Here's three different crimping methods/tools. The bench vise method was the first way I did this. (The wood block is one half of the stay ovalizing blocks I hand filed a long...
Forum: Framebuilders
04-18-21, 04:04 PM
Replies: 21
Views: 1,928
Posted By Andrew R Stewart

gilmo- If you are near me I will offer some tool...

gilmo- If you are near me I will offer some tool loans or help. Location in your bio helps us to guide you better. Andy
Forum: Framebuilders
04-12-21, 08:30 PM
Replies: 21
Views: 1,928
Posted By Andrew R Stewart

Given the history of chainstay cracks at the...

Given the history of chainstay cracks at the crimps the 753 ones reportedly suffer from don't do it. My memory says that Reynolds subbed 531 stays and blades early on after the initial introduction...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.