Bike Forums

Go Back  Bike Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Andrew R Stewart
Showing results 1 to 4 of 4
Search took 0.02 seconds.
Forum: Framebuilders
12-18-21, 06:58 PM
Replies: 10
Views: 1,163
Posted By Andrew R Stewart

I hope the steerer's cross threading is from a...

I hope the steerer's cross threading is from a race or top nut, only mushing the threads about, and not a die that cuts. Andy
Forum: Framebuilders
12-18-21, 02:18 PM
Replies: 10
Views: 1,163
Posted By Andrew R Stewart

Interesting that the OP has concerns about common...

Interesting that the OP has concerns about common vent hole but not re raking:)

I suggest doing any mods to the fork before using heat on it. Andy
Forum: Framebuilders
12-17-21, 09:22 PM
Replies: 10
Views: 1,163
Posted By Andrew R Stewart

The second issue is how the fork was offered....

The second issue is how the fork was offered. Were the holes shown or mentioned? If so than you have no claim. If not then maybe. IIRC the usual was for a hole up near the crown and another near the...
Forum: Framebuilders
12-17-21, 09:00 PM
Replies: 10
Views: 1,163
Posted By Andrew R Stewart

Given the early 1970s bike boom demands and...

Given the early 1970s bike boom demands and Raleigh's known consistency issues then I have no surprise at the holes not lining up.

What's the goal w/ this fork? Why do the holes have to be gone?...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.