Cracked frame 2016 Trek Emonda
#1
Junior Member
Thread Starter
Join Date: Apr 2019
Posts: 8
Likes: 0
Liked 0 Times
in
0 Posts
Cracked frame 2016 Trek Emonda
Bought this 2016 Emonda in mid 2017. There were no marks, scuffs, anything (it looked brand new), when I bought it 2nd hand. In late March 2019 I noticed cracks in frame (pictured) under seat pole, on both sides of frame. I'm perplexed how this has happened. No drops, no accidents, treated well etc. Has anyone else seen similar cracks on other Trek bikes? I found out later that the lifetime frame warranty only applies to 1st owner. Trek Australia have said they're not willing to do anything under warranty. They also refuse to assist in any other way such as providing store credit of any amount on purchase of new bike.
Is this acceptable that a 3 year old frame has cracked when there are no signs of damage to bike (apart from cracks)?
I have had this bike serviced several times at Trek previously. I've been told on each occasion that the bike is in good condition.
Finally, if the original owner did something that has now caused the cracks, would it take 2 years to be noticeable?
Is this acceptable that a 3 year old frame has cracked when there are no signs of damage to bike (apart from cracks)?
I have had this bike serviced several times at Trek previously. I've been told on each occasion that the bike is in good condition.
Finally, if the original owner did something that has now caused the cracks, would it take 2 years to be noticeable?
#2
Advocatus Diaboli
Join Date: Feb 2015
Location: Wherever I am
Posts: 8,724
Bikes: Merlin Cyrene, Nashbar steel CX
Liked 1,558 Times
in
1,022 Posts
Sounds like a run o'the mill asplosion..
FYI, you can't post pics until you have another 10 or so posts on BF
![Popcorn](images/smilies/popcorn.gif)
#3
On Your Left
Join Date: Nov 2011
Location: Long Island, New York, USA
Posts: 8,373
Bikes: Trek Emonda SLR, Sram eTap, Zipp 303
Liked 2,434 Times
in
1,187 Posts
I have a 2015 Emonda SLR with 22,000 miles. Zero problems not caused by me.
Which frameset is yours?
Which frameset is yours?
#4
Should Be More Popular
Join Date: Dec 2007
Location: Malvern, PA (20 miles West of Philly)
Posts: 43,286
Bikes: 1986 Alpine (steel road bike), 2009 Ti Habenero, 2013 Specialized Roubaix
Liked 9,194 Times
in
4,257 Posts
#5
Zoom zoom zoom zoom bonk
Join Date: Sep 2006
Location: New Zealand
Posts: 4,652
Bikes: Giant Defy, Trek 1.7c, BMC GF02, Fuji Tahoe, Scott Sub 35, Kona Rove, Trek Verve+2
Liked 737 Times
in
375 Posts
Can you contact the original owner? He might want that bike you "borrowed" from him back for a few weeks.
#7
Senior Member
Join Date: Jan 2010
Location: TC, MN
Posts: 39,520
Bikes: R3 Disc, Haanjo
Liked 9,456 Times
in
4,672 Posts
Are the cracks just cosmetic/in the paint? Wouldn't be surprised if that were the case.
Regardless, no, you're not entitled to any type of warranty support/coverage; it's one of the primary benefits of buying new and shouldn't be expected when buying used.
Regardless, no, you're not entitled to any type of warranty support/coverage; it's one of the primary benefits of buying new and shouldn't be expected when buying used.
#8
On Your Left
Join Date: Nov 2011
Location: Long Island, New York, USA
Posts: 8,373
Bikes: Trek Emonda SLR, Sram eTap, Zipp 303
Liked 2,434 Times
in
1,187 Posts
#9
Senior Member
I also wouldn't be surprised if it was just a crack in the paint or clear coat (or whatever finish they use).
If it is a true carbon crack, it could be repaired. I snapped off a seat stay on a Cervelo carbon frame about 5 years ago in a crash. The seat stay was broken all the way through. I sent it to a carbon frame repair place (can't recall who I used) and they repaired the frame. As I recall it cost about $300. I have since used it outside for the last 5 years and it has been perfect. They just rewrap the area with carbon fiber and epoxy. It would probably be stronger than the original carbon.
If it is a true carbon crack, it could be repaired. I snapped off a seat stay on a Cervelo carbon frame about 5 years ago in a crash. The seat stay was broken all the way through. I sent it to a carbon frame repair place (can't recall who I used) and they repaired the frame. As I recall it cost about $300. I have since used it outside for the last 5 years and it has been perfect. They just rewrap the area with carbon fiber and epoxy. It would probably be stronger than the original carbon.
#10
Senior Member
#11
Senior Member
[MENTION=497267]RichoBrisbane[/MENTION]'s Album/Gallery:
https://www.bikeforums.net/g/user/497267
https://www.bikeforums.net/g/album/13425169
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/1500x2000/80-img_20190407_092130_4a72f6cecf75ed1175a98ac65a3259dcd168f345.jpg)
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/1500x2000/80-img_20190407_092028_2e9afbef00e2cfcd85c867ebd72094897fdd04e0.jpg)
https://www.bikeforums.net/g/user/497267
https://www.bikeforums.net/g/album/13425169
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/1500x2000/80-img_20190407_092130_4a72f6cecf75ed1175a98ac65a3259dcd168f345.jpg)
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/1500x2000/80-img_20190407_092028_2e9afbef00e2cfcd85c867ebd72094897fdd04e0.jpg)
![](https://cimg2.ibsrv.net/gimg/bikeforums.net-vbulletin/1500x2000/80-img_20190407_092109_06b2b9204840bef340da361731adf4f206435ec1.jpg)
#13
Junior Member
Thread Starter
Join Date: Apr 2019
Posts: 8
Likes: 0
Liked 0 Times
in
0 Posts
#14
Junior Member
Thread Starter
Join Date: Apr 2019
Posts: 8
Likes: 0
Liked 0 Times
in
0 Posts
I also wouldn't be surprised if it was just a crack in the paint or clear coat (or whatever finish they use).
If it is a true carbon crack, it could be repaired. I snapped off a seat stay on a Cervelo carbon frame about 5 years ago in a crash. The seat stay was broken all the way through. I sent it to a carbon frame repair place (can't recall who I used) and they repaired the frame. As I recall it cost about $300. I have since used it outside for the last 5 years and it has been perfect. They just rewrap the area with carbon fiber and epoxy. It would probably be stronger than the original carbon.
If it is a true carbon crack, it could be repaired. I snapped off a seat stay on a Cervelo carbon frame about 5 years ago in a crash. The seat stay was broken all the way through. I sent it to a carbon frame repair place (can't recall who I used) and they repaired the frame. As I recall it cost about $300. I have since used it outside for the last 5 years and it has been perfect. They just rewrap the area with carbon fiber and epoxy. It would probably be stronger than the original carbon.
#15
Junior Member
Thread Starter
Join Date: Apr 2019
Posts: 8
Likes: 0
Liked 0 Times
in
0 Posts
#17
I didn't read all of the comments, but, did you do the tap test? The squeeze test?
Looking at this... doesn't look good.. But I've had some ugly cracks that wound up just in the paint.
Although, I should state for the record that I, personally am super paranoid, especially after my latest crash.. so, I see a crack I'm not taking ANY chances. It's unfortunate this happened to you.
Looking at this... doesn't look good.. But I've had some ugly cracks that wound up just in the paint.
Although, I should state for the record that I, personally am super paranoid, especially after my latest crash.. so, I see a crack I'm not taking ANY chances. It's unfortunate this happened to you.
#18
Senior Member
Trek Decoupled Frame?
It is hard to say what I'd do. I agree with [MENTION=454992]motosonic[/MENTION], that perhaps a little more testing.
Then, I can't say what I'd do.
How aggressive of a rider are you? If super aggressive/racing, then likely replace.
I'd be tempted to mark the ends of the cracks to monitor for progressing, then keep riding. Perhaps use the bike on a trainer, or for more mundane rides, at least until you determine your comfort level.
Wrap with Hemp?
It is hard to say what I'd do. I agree with [MENTION=454992]motosonic[/MENTION], that perhaps a little more testing.
Then, I can't say what I'd do.
How aggressive of a rider are you? If super aggressive/racing, then likely replace.
I'd be tempted to mark the ends of the cracks to monitor for progressing, then keep riding. Perhaps use the bike on a trainer, or for more mundane rides, at least until you determine your comfort level.
Wrap with Hemp?
#19
#20
Senior Member
Join Date: May 2010
Location: Bristol, R. I.
Posts: 4,340
Bikes: Specialized Secteur, old Peugeot
Liked 496 Times
in
299 Posts
In that particular area it would be difficult to get complete compaction of the plies causing air pockets that would result in the tendency to get some movement in the frame. I suspect it is not likely to get a catastrophic failure judging from what is visible but I would monitor the area regularly. The other course of action would be for a repair shop to grind down into the carbon to reach the solid laminate and build up with proper plies.
There is a video of a well known carbon frame where the investigator cut the frame open which revealed such air pockets. I did not bookmark the video and don't wish to search for it now. It only takes a little lack of care to get very poor result.
There is a video of a well known carbon frame where the investigator cut the frame open which revealed such air pockets. I did not bookmark the video and don't wish to search for it now. It only takes a little lack of care to get very poor result.
#21
Banned
#22
Senior Member
Join Date: Jul 2007
Location: South shore, L.I., NY
Posts: 7,074
Bikes: Flyxii FR322, Cannondale Topstone, Miyata City Liner, Specialized Chisel, Specialized Epic Evo
Liked 2,205 Times
in
1,250 Posts
Others have stated to ride and watch.
Personally I would just lay out $400 for a Chinese carbon and walk the parts over. You'd likely need a new -bracket if that Emoda is press-fit. I'd go BSA and new crank.
Personally I would just lay out $400 for a Chinese carbon and walk the parts over. You'd likely need a new -bracket if that Emoda is press-fit. I'd go BSA and new crank.
#23
Junior Member
Thread Starter
Join Date: Apr 2019
Posts: 8
Likes: 0
Liked 0 Times
in
0 Posts
Bought this 2016 Emonda in mid 2017. There were no marks, scuffs, anything (it looked brand new), when I bought it 2nd hand. In late March 2019 I noticed cracks in frame (pictured) under seat pole, on both sides of frame. I'm perplexed how this has happened. No drops, no accidents, treated well etc. Has anyone else seen similar cracks on other Trek bikes? I found out later that the lifetime frame warranty only applies to 1st owner. Trek Australia have said they're not willing to do anything under warranty. They also refuse to assist in any other way such as providing store credit of any amount on purchase of new bike.
Is this acceptable that a 3 year old frame has cracked when there are no signs of damage to bike (apart from cracks)?
I have had this bike serviced several times at Trek previously. I've been told on each occasion that the bike is in good condition.
Finally, if the original owner did something that has now caused the cracks, would it take 2 years to be noticeable?
Is this acceptable that a 3 year old frame has cracked when there are no signs of damage to bike (apart from cracks)?
I have had this bike serviced several times at Trek previously. I've been told on each occasion that the bike is in good condition.
Finally, if the original owner did something that has now caused the cracks, would it take 2 years to be noticeable?
#24
Senior Member
Join Date: Jan 2010
Location: Walnut Creek, CA
Posts: 2,669
Bikes: 2023 Canyon Aeoroad CF SL, 2015 Trek Emonda SLR, 2002 Litespeed Classic, 2005 Bianchi Pista, Some BikesDirect MTB I never ride.
Liked 139 Times
in
90 Posts
Meh, I'd keep riding it if it were me. If you're not a super heavy guy, and aren't riding on cobbles, or off road, I'd just keep riding it and monitor it for crack propagation. My 2010 Trek developed a few of these hairline "cracks" and it didn't bother me. I kept an eye on it, and it never became a problem. I wasn't even convinced they went all the way through the frame. Your photos look a little bit worse, but not by much...they may just be surface cracks and not all the way through...
#25
Senior Member
Join Date: Jan 2010
Location: Walnut Creek, CA
Posts: 2,669
Bikes: 2023 Canyon Aeoroad CF SL, 2015 Trek Emonda SLR, 2002 Litespeed Classic, 2005 Bianchi Pista, Some BikesDirect MTB I never ride.
Liked 139 Times
in
90 Posts
![foo](vb/cache//ds.jpg)