Anyone Used Gorilla Glue On TPU?
#1
Senior Member
Thread Starter
Join Date: May 2010
Location: Bastrop Texas
Posts: 4,771
Bikes: Univega, Peu P6, Peu PR-10, Ted Williams, Peu UO-8, Peu UO-18 Mixte, Peu Dolomites
Liked 1,848 Times
in
1,184 Posts
Anyone Used Gorilla Glue On TPU?
I have not gone the TPU route yet but the size and portability of the TPU tubes is quite inviting. It would appear that repair of flats in TPU can be a bugger. Many of the commercial flat fix kits for TPU have a history of failure unless put on under ideal conditions. I have been looking a round for a suitable portable glue for TPU specifically. There are a few and some of them are not only expensive but dangerous.
Has anyone used Gorilla Glue for repairing TPU tubes? And what technique did you use?
Note: If any of ya all have old trashed TPU tubes I can experiment with let me know. Ill pay the shipping.
Has anyone used Gorilla Glue for repairing TPU tubes? And what technique did you use?
Note: If any of ya all have old trashed TPU tubes I can experiment with let me know. Ill pay the shipping.
__________________
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)
Last edited by zandoval; 05-25-24 at 01:14 PM.
#2
Senior Member
Join Date: Mar 2022
Location: Missoula MT
Posts: 1,887
Bikes: Handsome xoxo, Serotta atx, Canyon Endurace CF8
Liked 2,078 Times
in
913 Posts
I have 100% success rate with schwalbe and park glueless patch kits one has over 3000 miles with no leaking. I am a bumbling drunk and have no issues patching tpu tubes. The patch with over 3000 miles is over a pretty big hole made by a sharp stick.
Likes For jadmt: