Need some advice, which cranks of these two? note I already have both!
#1
Senior Member
Thread Starter
Join Date: Jul 2013
Posts: 72
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Need some advice, which cranks of these two? note I already have both!
So basically I've acquired me a TREK Fuel ex 9 2007 frame. I bought two sets of cranks, a pair of shimano xtr m970 (run in single speed) and a pair of 83mm Raceface Atlas cranks. I'm just gonna run single speed, which one should I put on? Figured I'd ask you guys! With the raceface I'll need some adapters of some kind as my bb is 68mm. Thanks!
#2
Senior Member
Join Date: Oct 2007
Location: West Yorkshire, United Kingdom
Posts: 5,773
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quoted: 454 Post(s)
Liked 104 Times
in
87 Posts
Of the 2, would go for the XTR (this is on the basis you already have it setup as a singlespeed/ring) Using an 83mm BB crank will give you issues with the chainline, if you can even get it to fit your frame (see this thread for issues and possible solutions https://www.bikeforums.net/showthread...n-73mm-68mm-bb ) with the M970, the BCD is standard 64mm/104mm, but is offset, so you may need to use spacers to correct the chainline.
#3
Senior Member
Thread Starter
Join Date: Jul 2013
Posts: 72
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Of the 2, would go for the XTR (this is on the basis you already have it setup as a singlespeed/ring) Using an 83mm BB crank will give you issues with the chainline, if you can even get it to fit your frame (see this thread for issues and possible solutions https://www.bikeforums.net/showthread...n-73mm-68mm-bb ) with the M970, the BCD is standard 64mm/104mm, but is offset, so you may need to use spacers to correct the chainline.