105 R7000 Pedal Sticks...
#1
Full Member
Thread Starter
Join Date: Jun 2022
Posts: 295
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 193 Post(s)
Likes: 0
Liked 37 Times
in
32 Posts
105 R7000 Pedal Sticks...
Hey all. I have a new pair of 105 R7000 pedals. Less than 100 miles on them and the drive-side pedal sticks. It just stays in the position that it was left in. No movement at all unless force is applied. Is that normal? The left pedal falls into place, no problem. Should I regrease the pedal? And suggestions? Thank you!
#2
Senior Member
Join Date: May 2021
Posts: 8,847
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 4614 Post(s)
Liked 5,160 Times
in
3,189 Posts
It will loosen up with a bit more mileage. No need to re-grease it.
Likes For PeteHski:
#3
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 15,293
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 52 Post(s)
Tagged: 0 Thread(s)
Quoted: 6359 Post(s)
Liked 4,959 Times
in
3,414 Posts
I use pd-a520's and both sets took a few hundred miles to get where they'd fall to the clip in position. Maybe as much as 300 miles or more.
#5
Senior Member
Join Date: May 2021
Posts: 8,847
Mentioned: 16 Post(s)
Tagged: 0 Thread(s)
Quoted: 4614 Post(s)
Liked 5,160 Times
in
3,189 Posts
It is not unusual for R7000 pedals to be a bit sticky when new and they can vary from side to side. But you should be able to turn it easily with your hand. One might just have a bit more grease packed in there or a tighter tolerance.