Addiction 2024.2
04-29-24, 01:58 PM
#1826
Senior Member
Join Date: Sep 2005
Location: In the foothills of Los Angeles County
Posts: 25,430
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 8366 Post(s)
Liked 9,217 Times
in
4,541 Posts
Likes For big john:
04-29-24, 02:05 PM
#1827
VFL For Life
Join Date: Feb 2005
Location: Knoxville, TN
Posts: 51,401
Bikes: Velo Volmobile
Mentioned: 780 Post(s)
Tagged: 2 Thread(s)
Quoted: 28771 Post(s)
Liked 1,879 Times
in
1,335 Posts
04-29-24, 02:34 PM
#1828
Senior Member
Join Date: May 2016
Location: Yucatán. México
Posts: 6,389
Bikes: 79 Trek 930 is back on the road, 80 Trek 414, 84 Schwinn Letour Luxe,87 Schwinn Prelude, 92 Schwinn Paramount PDG 5
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3269 Post(s)
Liked 1,893 Times
in
1,192 Posts
106 degrees in Merida. Poco caliente
04-29-24, 03:23 PM
#1829
Senior Member
Join Date: May 2016
Location: Yucatán. México
Posts: 6,389
Bikes: 79 Trek 930 is back on the road, 80 Trek 414, 84 Schwinn Letour Luxe,87 Schwinn Prelude, 92 Schwinn Paramount PDG 5
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3269 Post(s)
Liked 1,893 Times
in
1,192 Posts
My wheels now look like wheels! They still need to have the tensions measured and corrected, stress-relieved, and trued for good and all, but at this point, you could ride them!
I keep going over them looking for the mis-threaded spoke, but once I got into the rhythm (under-under-over; over-over-under) it was pretty straightforward. Taping the new rim to the old wheel worked great!
Each set of spokes came out easily, till I got to the rear drive side. Whoever built the wheel years ago used some thread locker/spoke prep that really held the spokes TIGHT. Every spoke, each turn of the spoke wrench, the spoke would wind up, then *TICK!*, over and over again, all the way up the threads. The others, I could just back it off a bit with the spoke wrench then use the nipple driver the rest of the way. Not these. The stuff on the threads was reddish brown, and hardened after all these years. ONLY the drive side on the rear.
I keep going over them looking for the mis-threaded spoke, but once I got into the rhythm (under-under-over; over-over-under) it was pretty straightforward. Taping the new rim to the old wheel worked great!
Each set of spokes came out easily, till I got to the rear drive side. Whoever built the wheel years ago used some thread locker/spoke prep that really held the spokes TIGHT. Every spoke, each turn of the spoke wrench, the spoke would wind up, then *TICK!*, over and over again, all the way up the threads. The others, I could just back it off a bit with the spoke wrench then use the nipple driver the rest of the way. Not these. The stuff on the threads was reddish brown, and hardened after all these years. ONLY the drive side on the rear.
04-29-24, 05:45 PM
#1830
Not actually Tmonk
Join Date: Jun 2007
Location: San Diego, CA
Posts: 14,249
Bikes: road, track, mtb
Mentioned: 142 Post(s)
Tagged: 0 Thread(s)
Quoted: 2703 Post(s)
Liked 3,269 Times
in
1,714 Posts
Still Truckin' over here
__________________
"Your beauty is an aeroplane;
so high, my heart cannot bear the strain." -A.C. Jobim, Triste
"Your beauty is an aeroplane;
so high, my heart cannot bear the strain." -A.C. Jobim, Triste
04-29-24, 06:03 PM
#1831
Senior Member
Join Date: May 2016
Location: Yucatán. México
Posts: 6,389
Bikes: 79 Trek 930 is back on the road, 80 Trek 414, 84 Schwinn Letour Luxe,87 Schwinn Prelude, 92 Schwinn Paramount PDG 5
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3269 Post(s)
Liked 1,893 Times
in
1,192 Posts
04-29-24, 06:22 PM
#1832
Should Be More Popular
Join Date: Dec 2007
Location: Malvern, PA (20 miles West of Philly)
Posts: 43,168
Bikes: 1986 Alpine (steel road bike), 2009 Ti Habenero, 2013 Specialized Roubaix
Mentioned: 560 Post(s)
Tagged: 2 Thread(s)
Quoted: 22689 Post(s)
Liked 9,032 Times
in
4,202 Posts
04-29-24, 06:23 PM
#1833
Silver Comet Fred
Join Date: Jan 2017
Location: NW Metro Atl.
Posts: 12,173
Bikes: 1
Mentioned: 145 Post(s)
Tagged: 2 Thread(s)
Quoted: 8898 Post(s)
Liked 3,056 Times
in
1,768 Posts
04-29-24, 06:34 PM
#1834
cowboy, steel horse, etc
Join Date: Sep 2008
Location: The hot spot.
Posts: 45,035
Bikes: everywhere
Mentioned: 74 Post(s)
Tagged: 1 Thread(s)
Quoted: 12887 Post(s)
Liked 7,803 Times
in
4,141 Posts
04-29-24, 06:38 PM
#1835
Mostly Harmless
Join Date: Jul 2008
Location: Chittenango, NY
Posts: 56,665
Bikes: Have two wheels
Mentioned: 169 Post(s)
Tagged: 2 Thread(s)
Quoted: 13759 Post(s)
Liked 4,566 Times
in
2,527 Posts
04-29-24, 06:43 PM
#1836
Not actually Tmonk
Join Date: Jun 2007
Location: San Diego, CA
Posts: 14,249
Bikes: road, track, mtb
Mentioned: 142 Post(s)
Tagged: 0 Thread(s)
Quoted: 2703 Post(s)
Liked 3,269 Times
in
1,714 Posts
How the hell does it go from freezing rain to 90 in a few weeks? That ain't right. Most be an East Coast thing
__________________
"Your beauty is an aeroplane;
so high, my heart cannot bear the strain." -A.C. Jobim, Triste
"Your beauty is an aeroplane;
so high, my heart cannot bear the strain." -A.C. Jobim, Triste
04-29-24, 07:05 PM
#1837
Senior Member
Join Date: May 2022
Location: USA - Southwest PA
Posts: 3,185
Bikes: Cannondale - Gary Fisher - Giant - Litespeed - Schwinn Paramount - Schwinn (lugged steel) - Trek OCLV
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 1439 Post(s)
Liked 1,988 Times
in
1,132 Posts
04-29-24, 07:07 PM
#1838
Silver Comet Fred
Join Date: Jan 2017
Location: NW Metro Atl.
Posts: 12,173
Bikes: 1
Mentioned: 145 Post(s)
Tagged: 2 Thread(s)
Quoted: 8898 Post(s)
Liked 3,056 Times
in
1,768 Posts
BAM is cheating on us in the your bike near water thread. Sad.
On the good side he didn't get eaten by a bear.
On the good side he didn't get eaten by a bear.
Likes For DougRNS:
04-29-24, 07:27 PM
#1839
Not actually Tmonk
Join Date: Jun 2007
Location: San Diego, CA
Posts: 14,249
Bikes: road, track, mtb
Mentioned: 142 Post(s)
Tagged: 0 Thread(s)
Quoted: 2703 Post(s)
Liked 3,269 Times
in
1,714 Posts
04-29-24, 07:28 PM
#1840
• —
Join Date: Jun 2015
Location: Land of Pleasant Living
Posts: 12,302
Bikes: Shmikes
Mentioned: 59 Post(s)
Tagged: 0 Thread(s)
Quoted: 10212 Post(s)
Liked 5,919 Times
in
3,190 Posts
If you have not done so, you may want to go get an opinion from a university hospital academic rheumatologist who specializes in challenging and/or tough to treat patients with RA. Be sure to bring a full history of your relevant labs as well as a summary of treatments you have tried and what they did/did not do for your symptoms.
04-29-24, 07:50 PM
#1841
VFL For Life
Join Date: Feb 2005
Location: Knoxville, TN
Posts: 51,401
Bikes: Velo Volmobile
Mentioned: 780 Post(s)
Tagged: 2 Thread(s)
Quoted: 28771 Post(s)
Liked 1,879 Times
in
1,335 Posts
04-29-24, 08:26 PM
#1842
cowboy, steel horse, etc
Join Date: Sep 2008
Location: The hot spot.
Posts: 45,035
Bikes: everywhere
Mentioned: 74 Post(s)
Tagged: 1 Thread(s)
Quoted: 12887 Post(s)
Liked 7,803 Times
in
4,141 Posts
In other Kei car news, a neighbor just scored this sweet Samurai. I think this model exceeds Kei specs, but still tiny and rad!!!
04-29-24, 08:38 PM
#1843
VFL For Life
Join Date: Feb 2005
Location: Knoxville, TN
Posts: 51,401
Bikes: Velo Volmobile
Mentioned: 780 Post(s)
Tagged: 2 Thread(s)
Quoted: 28771 Post(s)
Liked 1,879 Times
in
1,335 Posts
I googled to learn why a rheumatologist would be needed in a hospital. I'm still not sure.
04-29-24, 08:42 PM
#1844
cowboy, steel horse, etc
Join Date: Sep 2008
Location: The hot spot.
Posts: 45,035
Bikes: everywhere
Mentioned: 74 Post(s)
Tagged: 1 Thread(s)
Quoted: 12887 Post(s)
Liked 7,803 Times
in
4,141 Posts
Dang it, just broke down and placed a tyre order yesterday. I keep forgetting there's a free tyre pole in town though.
Oh well, if there are any Sixers on there they're probably crappy wire bead commuter junk anyways
Oh well, if there are any Sixers on there they're probably crappy wire bead commuter junk anyways
Likes For LesterOfPuppets:
04-29-24, 08:49 PM
#1845
Senior Member
Join Date: Sep 2005
Location: In the foothills of Los Angeles County
Posts: 25,430
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 8366 Post(s)
Liked 9,217 Times
in
4,541 Posts
Likes For big john:
Likes For gnome:
04-30-24, 05:08 AM
#1847
Senior Member
Join Date: Jan 2010
Posts: 39,455
Mentioned: 211 Post(s)
Tagged: 1 Thread(s)
Quoted: 18504 Post(s)
Liked 15,817 Times
in
7,427 Posts
04-30-24, 06:03 AM
#1848
Senior Member
Join Date: Oct 2010
Posts: 8,556
Mentioned: 69 Post(s)
Tagged: 0 Thread(s)
Quoted: 3256 Post(s)
Liked 2,567 Times
in
1,529 Posts
https://www.globalsuzuki.com/automobile/lineup/jimny/
Last edited by seypat; 04-30-24 at 06:16 AM.
04-30-24, 06:08 AM
#1849
• —
Join Date: Jun 2015
Location: Land of Pleasant Living
Posts: 12,302
Bikes: Shmikes
Mentioned: 59 Post(s)
Tagged: 0 Thread(s)
Quoted: 10212 Post(s)
Liked 5,919 Times
in
3,190 Posts
They admit patients who require inpatient care and consult to other services on patients with rheumatological issues. Virtually all hospitals in the US have rheumatologists on staff. However, just because someone is associated with a hospital doesn't mean they spend all their time there.
Likes For MoAlpha:
04-30-24, 06:43 AM
#1850
Senior Member
Join Date: Jan 2010
Posts: 39,455
Mentioned: 211 Post(s)
Tagged: 1 Thread(s)
Quoted: 18504 Post(s)
Liked 15,817 Times
in
7,427 Posts
Chilcy to Cold at night. Nice during the day. Saw two bald eagles and heard two foxes screaming. Got tasty clam strips in Rehoboth. Pulled into a city park and spooked a Great Blue Heron that was crouched down by the edge of a pond. The wind was the real negative. When I first got off the ferry back in NJ, I could only manage 4 mph on one wide open stretch leading to a bike bath. Panniers make great sails.