Half Link Challenge!
#1
Senior Member
Thread Starter
Join Date: Dec 2011
Location: NE Ohio
Posts: 2,595
Bikes: 1992 Serotta Colorado II,Co-Motion Speedster, Giant Escape Hybrid, 1977 Schwinn Super Le Tour
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 455 Post(s)
Likes: 0
Liked 112 Times
in
85 Posts
Half Link Challenge!
On my wife's touring bike it uses a Rohloff with an 8 speed chain. Along with sliding rear dropouts I use a half link to dial in the chain length. I want to get a spare for the kit but seem to be run into a width problem. Wondering if anyone has a better understanding of what size to use?
Thanks!
Thanks!
#2
Senior Member
Join Date: Dec 2008
Location: Pioneer Valley
Posts: 1,008
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 332 Post(s)
Liked 742 Times
in
385 Posts
The width just needs to match the chain you’re using. Usually will be either 1/8” or 3/32” for an internal gear setup. But why would you need a half link with sliding dropouts?
Likes For bboy314:
#3
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,093
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4208 Post(s)
Liked 3,875 Times
in
2,315 Posts
Half links can be used to fine tune the position of the BB (as with eccentric) or the rear axle (and thus rim WRT brakes) to suit those aspects best set up. Seat set back and brake pad location in the arm can be juggled. Andy
__________________
AndrewRStewart
AndrewRStewart
Likes For Andrew R Stewart:
#4
Senior Member
Thread Starter
Join Date: Dec 2011
Location: NE Ohio
Posts: 2,595
Bikes: 1992 Serotta Colorado II,Co-Motion Speedster, Giant Escape Hybrid, 1977 Schwinn Super Le Tour
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 455 Post(s)
Likes: 0
Liked 112 Times
in
85 Posts
I went back out to my shop and git out the calipers again and remeasured. I had 2 half links of different sizes both from QBP. I "think" my last one was labeled incorrectly so I am reordering.
Andy you are spot on -I do it to fine tune the chain length.
Andy you are spot on -I do it to fine tune the chain length.
#5
Senior Member
Join Date: Dec 2008
Location: Pioneer Valley
Posts: 1,008
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 332 Post(s)
Liked 742 Times
in
385 Posts
EDIT: never mind! I was having trouble visualizing but I do see how the half link would give finer tuning of chain length.
Last edited by bboy314; 06-22-22 at 07:23 AM.