Wheel sensor for Cateye Velo 7
10-06-14, 12:16 PM
#1
Senior Member
Thread Starter
Join Date: Dec 2012
Location: Okefenokee Swamps.
Posts: 577
Bikes: Rockhopper, Azor Oma cruiser
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Likes: 0
Liked 2 Times
in
2 Posts
Wheel sensor for Cateye Velo 7
Is the little magnet that secures to the spokes, should it be affixed to both spokes near where they cross close to the hub?? Or is the unit meant to be attached to only one spoke??
10-06-14, 12:53 PM
#2
Banned
Ideally closer to the hub where the rotation velocity is slower, and where the fork sensor can be closest .
10-07-14, 03:19 AM
#3
Senior Member
One spoke. there is a notch in one end of the plastic piece, which should fit the spoke, and then the magnet screws down on that to keep the magnet in place.
It seems to work OK, and I don't have a particular problem with it, but you do need to check the magnet hasn't been knocked out of alignment when fixing a flat, or if you need to remove the wheel for transport.
It seems to work OK, and I don't have a particular problem with it, but you do need to check the magnet hasn't been knocked out of alignment when fixing a flat, or if you need to remove the wheel for transport.
Thread
Thread Starter
Forum
Replies
Last Post
gman214
Clydesdales/Athenas (200+ lb / 91+ kg)
5
05-11-14 06:23 PM
