Dielectric grease to water-resistize lights?
#1
Senior Member
Thread Starter
Join Date: Oct 2015
Location: San Diego, California
Posts: 4,076
Bikes: Velo Orange Piolet
Mentioned: 28 Post(s)
Tagged: 0 Thread(s)
Quoted: 2228 Post(s)
Liked 2,011 Times
in
972 Posts
Dielectric grease to water-resistize lights?
My rear dynamo light looks pretty porous and has some electronics in there, so I was wondering if plugging up holes with dielectric grease would be a good idea. I hardly ever ride in the wet, but every now and then I do. The rear tire would blast water up right into the underside of the light if I rode over a wet surface.
#2
Randomhead
Join Date: Aug 2008
Location: Happy Valley, Pennsylvania
Posts: 24,408
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4 Post(s)
Liked 3,708 Times
in
2,527 Posts
I doubt it would hold up in that application. I use it on connections all the time.
Likes For unterhausen:
#3
Senior Member
Join Date: Aug 2010
Location: Madison, WI
Posts: 11,224
Bikes: 1961 Ideor, 1966 Perfekt 3 Speed AB Hub, 1994 Bridgestone MB-6, 2006 Airnimal Joey, 2009 Thorn Sherpa, 2013 Thorn Nomad MkII, 2015 VO Pass Hunter, 2017 Lynskey Backroad, 2017 Raleigh Gran Prix, 1980s Bianchi Mixte on a trainer. Others are now gone.
Mentioned: 48 Post(s)
Tagged: 0 Thread(s)
Quoted: 3466 Post(s)
Liked 1,470 Times
in
1,147 Posts
I run fenders, thus not much tire spray. But if I was concerned about it, I would put a layer of electrical tape over the open spaces in the bottom of the light and call that good. Probably need several pieces of tape to get much of a seal around the wires where they enter the light.
Likes For Tourist in MSN:
#4
Senior Member
Join Date: Feb 2008
Location: Peoria, IL
Posts: 4,485
Mentioned: 86 Post(s)
Tagged: 0 Thread(s)
Quoted: 1831 Post(s)
Liked 3,395 Times
in
1,587 Posts
pics??
For my funky homemade lights, I seal stuff up with silicone caulk, aka RTV. Specifically, I like GE280, which is available at one of the local Ace hardware stores.
an example:
Steve in Peoria
For my funky homemade lights, I seal stuff up with silicone caulk, aka RTV. Specifically, I like GE280, which is available at one of the local Ace hardware stores.
an example:
Steve in Peoria