Niterider Mako 250 Light Repair Suggestions
#1
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Western Ma.
Posts: 963
Bikes: Diamondback "parkway" Spec. "expedition
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 48 Post(s)
Likes: 0
Liked 42 Times
in
33 Posts
Niterider Mako 250 Light Repair Suggestions
The small tabs on my Niterider Mako 250 are worn to the point where the head the light won't attach to the body.
Awaiting on call back from Niterider but, any suggestions on how to lock the 2 pieces together till then?
Awaiting on call back from Niterider but, any suggestions on how to lock the 2 pieces together till then?
Likes For holytrousers:
#3
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Western Ma.
Posts: 963
Bikes: Diamondback "parkway" Spec. "expedition
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 48 Post(s)
Likes: 0
Liked 42 Times
in
33 Posts
There are 3 tabs that lock the light head to the body. I is so worn it won't lock.
Using a hose clamp to keep the parts together,
Gorilla tape is not holding as the spring battery connectors are too strong.
Using a hose clamp to keep the parts together,
Gorilla tape is not holding as the spring battery connectors are too strong.
#4
Senior Member
Thread Starter
Join Date: Dec 2007
Location: Western Ma.
Posts: 963
Bikes: Diamondback "parkway" Spec. "expedition
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 48 Post(s)
Likes: 0
Liked 42 Times
in
33 Posts
Though I made a temp fix and the light works, Niterider is sending me a new unit w/o cost