Campagnolo Veloce Brifter Question
#1
Full Member
Thread Starter
Join Date: Dec 2008
Location: Denver Colorado
Posts: 271
Bikes: 70's Nuovo Record Jeunet Franche Compte, '88 105 Trek 1200, '85 Victory Bianchi Vittoria, '89 Exage Bianchi Strada LX, '11 Shimano Masi Partenza
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Quoted: 109 Post(s)
Liked 19 Times
in
15 Posts
Campagnolo Veloce Brifter Question
Quick question on brake levers that no one ever talks about; clamp size. I have a set of older Campy Veloce brifters on a bike that I want to change the bars on, and I was wondering if anyone knew off the top of their heads what bar diameter I need for those brifters. Thanks.
__________________
70's Nuovo Record Jeunet Franche Compte, '88 105 Trek 1200, '85 Victory Bianchi Vittoria, '89 Exage Bianchi Strada LX, & '11 Shimano Masi Partenza
70's Nuovo Record Jeunet Franche Compte, '88 105 Trek 1200, '85 Victory Bianchi Vittoria, '89 Exage Bianchi Strada LX, & '11 Shimano Masi Partenza
#2
Newbie
Veloce barbsize
I am a new member and have been reviewing old posts. I just removed Veloce brifters from a 3ttt Ergo Power
bar. The bar measures 26.0mm at the center section where it attaches to the stem, and about 24.1mm at the
end of the bar where the clamp slides over. I don’t know if the end OD of newer bars with a larger OD at the center section is the same as the old bars. Bill
bar. The bar measures 26.0mm at the center section where it attaches to the stem, and about 24.1mm at the
end of the bar where the clamp slides over. I don’t know if the end OD of newer bars with a larger OD at the center section is the same as the old bars. Bill