Where to mount a rear Light on a Road Bike with an Under Seat Bag?
#1
Senior Member
Thread Starter
Where to mount a rear Light on a Road Bike with an Under Seat Bag?
Bad picture but it's all I have right now. Is that the best way to mount the rear blinky light? Seems like it's facing downward a bit. Any other suggestions?
#2
Tinker-er
Join Date: Oct 2007
Location: Mid-Atlantic
Posts: 676
Bikes: 1956 Rudge Sports; 1983 Univega Alpina Uno; 1981 Miyata 610; 1973 Raleigh Twenty; 1994 Breezer Lightning XTR; V4 Yuba Mundo aka "The Schlepper"; 1987 Raleigh "The Edge" Mountain Trials; 1952 R.O. Harrison "Madison"; 1994 Concorde Aquila
Liked 425 Times
in
271 Posts
If I'm riding a bike without a dynohub, I personally use multiples; one on the bag, one on my belt or sweater scoop (pocket). If I'm on a bike that has built-in lighting, the rear light is high up on the left side seat stay, but still below the lowest point my bag can block; and that's a Carradice Barley, so it's a substantial bag. I haven't yet gotten one fit to the helmet, but that is a sensible idea too.
Likes For Bogey Speedwell:
#4
Senior Member
Some bags have places for lights to clip to. There are also mounting systems for lights to attached to the saddle. Some use mounts specific to a given saddle, but there are versions that attached to standard saddle rails. I've used something like that to mount a Garmin Varia radar unit. Even though the radar unit hangs down, it cleared the large Topeak wedge saddle bag I was using.
I got that at Bup Labs
https://buplabs.com/
I got that at Bup Labs
https://buplabs.com/
Likes For Mtracer:
#6
Senior Member
Join Date: Apr 2009
Location: New Rochelle, NY
Posts: 39,645
Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter
Liked 3,482 Times
in
1,912 Posts
I prefer using seat stay bracket. This lets me go as high as possible staying below the bag. If your seat is high enough, you can also improvise a bracket using the brake bolt.
__________________
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
FB
Chain-L site
An ounce of diagnosis is worth a pound of cure.
Just because I'm tired of arguing, doesn't mean you're right.
“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN
WARNING, I'm from New York. Thin skinned people should maintain safe distance.
#7
Senior Member
Join Date: Jan 2009
Location: Colorado Springs, CO
Posts: 6,052
Bikes: 2015 Charge Plug, 2007 Dahon Boardwalk, 1997 Nishiki Blazer, 1984 Nishiki International, 2006 Felt F65, 1989 Dahon Getaway V
Liked 1,760 Times
in
872 Posts
Here's my seat-stay mounted rear light from 9 years ago.
Likes For BobbyG:
#8
Full Member
Join Date: Oct 2023
Posts: 429
Bikes: '00 LS Vortex/Chorus 12/Campag Zondas, '98 LS Classic/Chorus 10/Rolf Vector Pros
Liked 365 Times
in
208 Posts
Last edited by 13ollocks; 03-21-24 at 10:40 AM.
Likes For 13ollocks:
#9
For The Fun of It
Join Date: May 2007
Location: Louisissippi Coast
Posts: 5,910
Bikes: Lynskey GR300, Lynskey Backroad, Litespeed T6, Lynskey MT29, Burley Duet
Liked 1,746 Times
in
864 Posts
Turn it on and walk a couple hundred feet away to see how it shows. Mine aren't perfectly oriented but still show bright.
Likes For roadfix:
#11
Senior Member
Join Date: Oct 2008
Location: Portland, OR
Posts: 4,077
Bikes: Trek Domane SL6 Gen 3, Soma Fog Cutter, Focus Mares AL, Detroit Bikes Sparrow FG, Volae Team, Nimbus MUni
Liked 2,322 Times
in
1,220 Posts
IMO the light needs to be rigidly mounted and aimed level. I don't use low seat stay anymore, after seeing a friend seemingly disappear a few hundred feet in front of me. The road was gently curving right, just so his wheel obscured the light. Yikes.
Seat stay above the wheel, or below bag level on the seat tube or seat post. This can be difficult on a short frame. An alternative is one on each seat stay. Helmet is a great second location, but isn't consistently aimed correctly to be primary.
Seat stay above the wheel, or below bag level on the seat tube or seat post. This can be difficult on a short frame. An alternative is one on each seat stay. Helmet is a great second location, but isn't consistently aimed correctly to be primary.
Likes For downtube42:
#12
Junior Member
When I buy rear lights, I make sure they have mounts for both seat post and seat stay. I use both. If you just use one on the seat stay, make sure it is on the side facing traffic and as high as possible.
I would never put a light on a seat bag, jersey pocket or backpack. Those lights are almost never facing the proper direction and are often not seen by approaching traffic. I use Cygolites, which come with both seat post and seat stay mounts, but many other brands offer them as well.
I would never put a light on a seat bag, jersey pocket or backpack. Those lights are almost never facing the proper direction and are often not seen by approaching traffic. I use Cygolites, which come with both seat post and seat stay mounts, but many other brands offer them as well.
#13
Full Member
Here's my thread when I had issues mounting my Garmin Varia
https://www.bikeforums.net/electroni...-question.html
https://www.bikeforums.net/electroni...-question.html
#14
Senior Member
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,653
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Liked 3,680 Times
in
2,381 Posts
left rear seat stay. there are lots of slender units out there now w/ decent mounts
#15
Senior Member
Probably not your cup of tea but every bike I use, I install a pannier rack. So I'd put the bike light at the very end of the pannier rack.
#16
Senior Member
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,653
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Liked 3,680 Times
in
2,381 Posts
#17
Standard Member
Join Date: Apr 2009
Location: Brunswick, Maine
Posts: 4,350
Bikes: 1948 P. Barnard & Son, 1962 Rudge Sports, 1963 Freddie Grubb Routier, 1980 Manufrance Hirondelle, 1983 F. Moser Sprint, 1989 Raleigh Technium Pre, 2001 Raleigh M80
Liked 1,055 Times
in
524 Posts
Get a clip-on type (Planet Bike has one), and clip it to the waist of your pants, your collar, or your pack.
__________________
"Chim-chiminey, chim-chiminey, chim-chim cheroo"
"Chim-chiminey, chim-chiminey, chim-chim cheroo"
#18
I have the issue that I have a low seat and I'm using a Surly rear cable hanger. I just got a Varia and then I mount it to the seatpost it hits the rear cable hanger and is forced sideways. Did you see anything that might help with that?
EDIT: here's a photo
EDIT: here's a photo
Last edited by Saxicola; 04-18-24 at 09:16 AM. Reason: added photo
#19
Likes For Saxicola:
#20
Senior Member
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 29,653
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Liked 3,680 Times
in
2,381 Posts
see post #9 here
mounting lights is similar to mounting fenders in that sometimes one has to be creative & crafty
Last edited by rumrunn6; 04-18-24 at 09:13 AM.
Likes For rumrunn6:
#21
Senior Member
Mount mine on the strap on the bag. In addition, planning to get a helmet mounted light.
#22
Senior Member
Join Date: Mar 2024
Location: San Diego
Posts: 1,206
Bikes: Columbine, Paramount Track Bike, Colnago Super, Santana Tandems (1995 & 2007), Gary Fisher Piranha, Trek Wahoo, Bianchi Track Bike, a couple of Honda mountain bikes
Liked 433 Times
in
267 Posts
After getting hit from behind on a wide straight road, I decided to come up with a better light than the typical bike light. Emergency vehicle flasher powered by a 12v makita battery. The one on our tandem is mounted to the rack and my commuter bike has one on the seatpost.
__________________
Cheers, Mike
-Stupid hurts....ride safe
Cheers, Mike
-Stupid hurts....ride safe
Likes For PromptCritical:
#23
Grupetto Bob
Join Date: Sep 2020
Location: Seattle-ish
Posts: 6,950
Bikes: Bikey McBike Face
Liked 6,608 Times
in
3,342 Posts
That is one ginormous seat bag which makes a seat post mount difficult.
Mine is half to a third of the size and contains: Spare tube, tire levers, tire boot, 3 patches and glue, multitool, valve core remover, 2 CO2s and head. I can affect any repair with what I carry. Yes it’s all crammed in there, but all of it fits, plus it is a bit more aero.
Consider a smaller bag, pack efficiently and then a seat post mount is no issue.
Mine is half to a third of the size and contains: Spare tube, tire levers, tire boot, 3 patches and glue, multitool, valve core remover, 2 CO2s and head. I can affect any repair with what I carry. Yes it’s all crammed in there, but all of it fits, plus it is a bit more aero.
Consider a smaller bag, pack efficiently and then a seat post mount is no issue.
__________________
Road 🚴🏾♂️ & Mountain 🚵🏾♂️
Road 🚴🏾♂️ & Mountain 🚵🏾♂️
Likes For rsbob:
#24
Newbie
For your consideration.....
Some of the vintage road bikes (like the 80's Nishiki I'm currently working on) had a bracket that mounted to the seatstays via the rear brake mounting. I'm not suggesting this exact approach on a modern bike, but something like that may be worth considering or give you an idea, especially if you have the tools and material to fabricate that type of bracket.
Btw, the road bike I ride most often has its rear light on the back of the rack, like PrompCritical shows above.
Some of the vintage road bikes (like the 80's Nishiki I'm currently working on) had a bracket that mounted to the seatstays via the rear brake mounting. I'm not suggesting this exact approach on a modern bike, but something like that may be worth considering or give you an idea, especially if you have the tools and material to fabricate that type of bracket.
Btw, the road bike I ride most often has its rear light on the back of the rack, like PrompCritical shows above.
#25
Senior Member
Join Date: Jul 2006
Location: Lebanon (Liberty Hill), CT
Posts: 8,758
Bikes: CAAD 12, MASI Gran Criterium S, Colnago World Cup CX & Guru steel
Liked 1,429 Times
in
835 Posts
I have a Garmin radar/light that mounts to the seat post. I also have a very bright rear light that mounts to a strap at the back of my tool bag.
Likes For bruce19: