Which cranknut do I need?
#1
Junior Member
Thread Starter
Join Date: Oct 2021
Posts: 8
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 6 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Which cranknut do I need?
Hi all,
Im missing a cranknut on my bike. Not sure which crankset i have but i think it's a hollowtech I (not II). I order this cranknut (shimano Y1P417000) but it is too big. Anyone know where i can find a smaller version?
Im missing a cranknut on my bike. Not sure which crankset i have but i think it's a hollowtech I (not II). I order this cranknut (shimano Y1P417000) but it is too big. Anyone know where i can find a smaller version?
#2
Senior Member
Join Date: May 2013
Location: Kips Bay, NY
Posts: 2,212
Bikes: Ritchey Swiss Cross | Teesdale Kona Hot | Haro Extreme | Specialized Stumpjumper Comp | Cannondale F1000 | Shogun 1000 | Cannondale M500 | Norco Charger | Marin Muirwoods 29er | Shogun Kaze | Breezer Lightning
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 576 Post(s)
Liked 1,002 Times
in
488 Posts
Hollowtech 1 can be square taper or octalink. I'd remove the bolt and look at the interface. If you see a square, you need something like this.
#3
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 14,987
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6193 Post(s)
Liked 4,809 Times
in
3,317 Posts
If it's a Shimano crank, there should be a part number on the inside of the crankarm just below the hole for the pedal. That'd make it easy to determine what you have.
If this turns out to be Hollowtech II then the "nut" you seem to be asking about is really of no use as long as you don't remove the crankarm. It's only used to get the crankarm into the proper position before the bolts are tightened. I don't recall ever seeing a Hollowtech crank, so I can't say if they are the same or not for what this fastener does.
Also, we are talking about the left side aren't we? There isn't one for the drive side.
If this turns out to be Hollowtech II then the "nut" you seem to be asking about is really of no use as long as you don't remove the crankarm. It's only used to get the crankarm into the proper position before the bolts are tightened. I don't recall ever seeing a Hollowtech crank, so I can't say if they are the same or not for what this fastener does.
Also, we are talking about the left side aren't we? There isn't one for the drive side.