Hood replacement question
09-14-21, 12:27 AM
#1
Senior Member
Thread Starter
Hood replacement question
2007 Specialized Tricross Comp here needing new hoods. Is there any way to replace the hoods without removing the shift cables at the lever? The shift cables are outside connecting to the levers at the sides, rather than routed under the bar tape. Doesn't seem possible but thought I'd ask.
Last edited by Richard8655; 09-14-21 at 12:36 AM.
09-14-21, 07:04 AM
#2
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
You could push out the lever's pivot pin and pull the brake lever and shifter assembly off of the base, then remove the hood and replace it. Reinstall the lever/shift assembly. Note that Shimano STIs have a set screw under the lever that retains the pivot pin so it has to be removed first.
Alternatively, loosen the entire lever assembly' clamp screw and pull the entire lever away from the bar's clamp band. Then peel the hood off toward the back of the assembly and replace with the new one.
Alternatively, loosen the entire lever assembly' clamp screw and pull the entire lever away from the bar's clamp band. Then peel the hood off toward the back of the assembly and replace with the new one.
Likes For HillRider:
09-14-21, 07:13 AM
#3
Senior Member
Thread Starter
Thanks much! Will take a look at those options.
