6600 Ultegra crank with 6750 drive train
#1
Semper Fidelis
Thread Starter
Join Date: Apr 2006
Posts: 3,000
Bikes: Tiemeyer Road Bike & Ridley Domicles
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 36 Post(s)
Likes: 0
Liked 1 Time
in
1 Post
6600 Ultegra crank with 6750 drive train
Currently my bike is running Ultegra 6700/with a compact 6750 crank. [same]
With the compact I am running a 11-23 and though I like it I prefer mashing to spinning.
If I buy a 6600 ultegra crank SLC 53/39 the light grey and run a new shimano chain and keep everything else as is, front der. and the full drive train except the crank will their be any problems with compatability and shifting.
Thanks in advance
Gary
With the compact I am running a 11-23 and though I like it I prefer mashing to spinning.
If I buy a 6600 ultegra crank SLC 53/39 the light grey and run a new shimano chain and keep everything else as is, front der. and the full drive train except the crank will their be any problems with compatability and shifting.
Thanks in advance
Gary
#2
Senior Member
You'll most likely need to raise the FD a little bit and do a little adjusting but it will work fine. I did the same thing in reverse with no issues.
#4
Senior Member
Join Date: Jul 2002
Posts: 6,956
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 6 Times
in
5 Posts
You'll probably want to leave the FD cable a little slack when it's in the small ring, because the rings are actually spaced a little closer together on 6600. Don't want your FD being totally rammed against its H screw.