New wheelset; problem with front hub
#1
CyclingBrian
Thread Starter
New wheelset; problem with front hub
I'm new to disc brakes. I got a new wheelset and the front is a 12x100mm (Thru-Axle). When I mounted the wheel on the bike, I noticed some place (wobble). I got my caliper out and measured the Hub width and its only 95mm. That's not normal right? The old wheel I'm replacing is 100mm. You wouldn't add washers to a thru axle to resolve this 5mm gap, would you? 2.5 each side? Doesn't seem right. Btw, the rear wheel is fine.
#2
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,092
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4208 Post(s)
Liked 3,874 Times
in
2,314 Posts
Are the wheels new? did you get them from a source that acres about their customers? If yes then contact them before you go further. It might be a simple fix as having the wrong axle end caps. Andy
__________________
AndrewRStewart
AndrewRStewart
Likes For Andrew R Stewart:
#3
CyclingBrian
Thread Starter
Mr Stewart.. END CAP kind of an important part. Figured this out. Thanks for the quick reply. Learned something new.