Adjusting rim brake spacing for wear? (cantilever)
#26
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 12,909
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Mentioned: 129 Post(s)
Tagged: 0 Thread(s)
Quoted: 4806 Post(s)
Liked 3,932 Times
in
2,557 Posts
A really good reason to tighten the cable as needed is exactly because it makes the cable a bit older. So after a couple of adjusts, you get tired of it and replace it. Why is this good? Because if you keep that end in showroom new condition, say for the next ten years, what happens? That cable snaps in a panic stop at the brake lever where you have never looked. (In fact, on many cabling systems, you cannot see that lever entry without loosening that cable clamp at the caliper.)
Brake cables are cheap. Crashes from broken cables often are not.
Baa ... Old thread. Guilty again.
Brake cables are cheap. Crashes from broken cables often are not.
Baa ... Old thread. Guilty again.