campy zero pos. 10sp bar end shifters: should they click both ways?
04-25-21, 04:06 PM
#1
Newbie
Thread Starter
Join Date: Apr 2021
Posts: 1
Bikes: Overburys Pioneer (1984), Spectrum Ti Randonneur (1999), Aegis tri (2010), Surly Straggler (2019)
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
campy zero pos. 10sp bar end shifters: should they click both ways?
After years of waiting, I'm finally repairing/upgrading my wife's campy 10 speed old-school bar end shifters with the last generation of 10sp bar end shifter they made, the so-called "zero position" ones that always return to the same position.
Stupid old bike mechanic that I am, I didn't bother to read the instructions, which are emphatic about NOT disassembling the lever mechanism. I did it anyway, realized my mistake, and tried to figure out how to to reset everything correctly. I believe I worked it out, and things are all shifting nicely.
However, it only clicks when shifting up (to a higher gear), not when shifting down (to a lower gear).
Does anyone know if this the intended behavior, or did I totally bork the shifters?
Stupid old bike mechanic that I am, I didn't bother to read the instructions, which are emphatic about NOT disassembling the lever mechanism. I did it anyway, realized my mistake, and tried to figure out how to to reset everything correctly. I believe I worked it out, and things are all shifting nicely.
However, it only clicks when shifting up (to a higher gear), not when shifting down (to a lower gear).
Does anyone know if this the intended behavior, or did I totally bork the shifters?
