Niterider adaptor
03-29-23, 09:34 AM
#1
Senior Member
Thread Starter
Join Date: Mar 2020
Location: Nevada County, California
Posts: 789
Bikes: Subject to change at any given moment but currently is...... Colnago Mapei, Colnago C40, Wilier Triestina Carbon, Wilier Triestina Ramato, Follis 472, Peugeot PX60, Razesa, Orbea Terra, Soma Pescadero and 1/2 owner of a Santana tandem.
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 331 Post(s)
Liked 782 Times
in
264 Posts
Niterider adaptor
I recently bought one of these to mount my Lumina 650 to the bottom of my K-Edge Wahoo handlebar mount. I originally believed that it was designed to permit quick removal but apparently that’s not true.
Looks like after you slide it into position you then tighten down the two small screws on the adaptor to hold it tight against the light, then tighten the screw passing through where the adapter joins the K-Edge.
All very solid but a bit of a process to remove the light for charging. Has anyone come up with a trick or tip to make removal faster and hopefully not require any tools ?
Looks like after you slide it into position you then tighten down the two small screws on the adaptor to hold it tight against the light, then tighten the screw passing through where the adapter joins the K-Edge.
All very solid but a bit of a process to remove the light for charging. Has anyone come up with a trick or tip to make removal faster and hopefully not require any tools ?
03-29-23, 10:45 AM
#2
Senior Member
Join Date: Jun 2002
Location: San Jose, CA
Posts: 3,691
Bikes: Too many bikes, too little time to ride
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 430 Post(s)
Liked 460 Times
in
318 Posts
Can you replace the bolt with one with a knob? Like what the GoPro mounts have?
Likes For tFUnK:
