TriPeak PFTF BB30 Bottom Brackets
10-05-23, 08:04 AM
#1
Newbie
Thread Starter
Join Date: Feb 2021
Posts: 8
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
TriPeak PFTF BB30 Bottom Brackets
Does anyone have experience with TriPeak bottom brackets?. I have a 2021 Santana Journey and yesterday I just replaced the stokers BB for the second time. Seems like the BB only lasts about 3K miles. I have made sure the gates belt tension is much lower than manufacturer specification to minimize side loading. On my old Santana and Cannondale MT800 BB lasted over 20K+ miles.
Stefan
Stefan
10-05-23, 12:24 PM
#2
Junior Member
I don't have experience with TriPeak bottom brackets, but I've had a lot of experience with different bearings over the years--and I've found that there's quite a range of quality. I don't know if they make bearing that will fit your bike, but I've always had good luck with Enduro Bearings: endurobearings.com.
10-05-23, 07:27 PM
#3
Newbie
Thread Starter
Join Date: Feb 2021
Posts: 8
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Does anyone have experience with TriPeak bottom brackets?. I have a 2021 Santana Journey and yesterday I just replaced the stokers BB for the second time. Seems like the BB only lasts about 3K miles. I have made sure the gates belt tension is much lower than manufacturer specification to minimize side loading. On my old Santana and Cannondale MT800 BB lasted over 20K+ miles.
Stefan
Stefan
Thank you for the link. Looks like they may have a direct replacement for the TriPeak BB that comes with life time warranty. It’s not cheap but less than the 2 I have had to replace.
