Ghost pedaling
#1
Member
Thread Starter
Join Date: Apr 2015
Location: Montreal
Posts: 36
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 6 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Ghost pedaling
Video of the problem: https://www.youtube.com/watch?v=YfKQ...ature=youtu.be
Hi guys, I'm experiencing some ghost pedaling as per the video above and my rear wheel isn't giving me my satisfying clicks when freewheeling anymore... is this cause for concern?
Thanks!
Hi guys, I'm experiencing some ghost pedaling as per the video above and my rear wheel isn't giving me my satisfying clicks when freewheeling anymore... is this cause for concern?
Thanks!
#2
I'm good to go!
Join Date: Jul 2017
Location: Mississippi
Posts: 14,992
Bikes: Tarmac Disc Comp Di2 - 2020
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
Quoted: 6195 Post(s)
Liked 4,810 Times
in
3,318 Posts
If you aren't having any real issues, why worry? Most of us will be happy to have a quiet hub. Wait till it gives you some actual trouble, then fix it.
#3
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 12,906
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Mentioned: 129 Post(s)
Tagged: 0 Thread(s)
Quoted: 4806 Post(s)
Liked 3,929 Times
in
2,554 Posts
Have you lubed the FW/cassette with a thin oil recently? It looks like it is need of either a lube or thinner lube and because of that isn't rotating freely. Now with the wheel spinning, bearing drag in the Fw means it is being spun, hence the chain and crankset and many few clicks are happening because not many pawls are sliding past the ratchet.
We used to lay the wheel on a table, FW up, then spin the FW as we poured light lube (good old 3 in 1 oil being a favorite of some). Keep spinning and pouring until we saw oil coming out the bottom/hub side. It's not quite as simple with a cassette because doing that probably will wash some grease out of the rightside hub bearing (unless it has good seals) but the cassette body will love it. Edit: I do this with my cassette wheels and just figure that the hub bearings will tell me when they are lo longer happy and I'll just replace them.
Ben
We used to lay the wheel on a table, FW up, then spin the FW as we poured light lube (good old 3 in 1 oil being a favorite of some). Keep spinning and pouring until we saw oil coming out the bottom/hub side. It's not quite as simple with a cassette because doing that probably will wash some grease out of the rightside hub bearing (unless it has good seals) but the cassette body will love it. Edit: I do this with my cassette wheels and just figure that the hub bearings will tell me when they are lo longer happy and I'll just replace them.
Ben