RS505 pistons
#1
• —
Thread Starter
Join Date: Jun 2015
Location: Land of Pleasant Living
Posts: 12,240
Bikes: Shmikes
Mentioned: 59 Post(s)
Tagged: 0 Thread(s)
Quoted: 10170 Post(s)
Liked 5,863 Times
in
3,155 Posts
RS505 pistons
Hello, experts. Just replaced a set of pads on a 1 yr old caliper and cannot eliminate rub. The pistons seemed sticky, particularly on one side, so I cleaned them several times with the Q-tip and brake oil method and worked the pistons in and out quite a bit. There was improvement, but the pistons—I think it's both—still work themselves back out to about 1-2 mm proud after a few brake cycles and stay there. Brake works fine, otherwise.
Normal? Doing something wrong? Wrong pads?
Normal? Doing something wrong? Wrong pads?
#2
Senior Member
Join Date: Aug 2006
Posts: 1,895
Mentioned: 8 Post(s)
Tagged: 0 Thread(s)
Quoted: 184 Post(s)
Likes: 0
Liked 67 Times
in
53 Posts
#3
• —
Thread Starter
Join Date: Jun 2015
Location: Land of Pleasant Living
Posts: 12,240
Bikes: Shmikes
Mentioned: 59 Post(s)
Tagged: 0 Thread(s)
Quoted: 10170 Post(s)
Liked 5,863 Times
in
3,155 Posts
Another method: https://www.pinkbike.com/video/478889/