Pizza Solutions
#1
Senior Member
Thread Starter
Join Date: Jan 2010
Location: Athens, GA
Posts: 133
Likes: 0
Liked 0 Times
in
0 Posts
Pizza Solutions
IMG_20100831_133755&.jpg
Surely a more elegant solution exists. Anybody have any suggestions or personal experiences? Pictures would be awesome.
Surely a more elegant solution exists. Anybody have any suggestions or personal experiences? Pictures would be awesome.
#2
Member
Join Date: Aug 2009
Posts: 49
Likes: 0
Liked 0 Times
in
0 Posts
don't have a photo but i put them on my xtracycle this way. big difference with my setup tho, the snapdeck is wider than a normal rear rack and it also has a 2" thick foam pad on it. i wrap the pizza box in a beach towel to add cushion and keep the heat in. i then strap it down with some nylon straps. its better to use more straps that aren't so tight than fewer straps that need to be tighter, so i use four 1" wide nylon straps.
its the only way i could figure out to do it, because unlike most cargo haul, the pizza obviously needs to be kept flat, and there really isn't anywhere else on the bike to do that.
i will take a photo next time i do it.
its the only way i could figure out to do it, because unlike most cargo haul, the pizza obviously needs to be kept flat, and there really isn't anywhere else on the bike to do that.
i will take a photo next time i do it.
#3
Banned
P clips screwed into a sheet of plywood will attach the wood platform to the rear rack.
then see if the pizza parlor will, sell you one of their delivery bags..
that is unless you are doing a Pizza by bike delivery then they will throw that in with your Job.
another thing is Porteur racks , style is hot these days in some circles , French newspaper delivery bikes 20 pound bundles..
from presses to the street corner kiosks where they got sold
Big front top of the wheel rack..
then see if the pizza parlor will, sell you one of their delivery bags..
that is unless you are doing a Pizza by bike delivery then they will throw that in with your Job.
another thing is Porteur racks , style is hot these days in some circles , French newspaper delivery bikes 20 pound bundles..
from presses to the street corner kiosks where they got sold
Big front top of the wheel rack..
#4
Full Member
Join Date: Jun 2010
Location: Orangeville, Ontario
Posts: 388
Likes: 0
Liked 0 Times
in
0 Posts
i just keep on hand on the handle bars and the other hand on the pizza box. if i was carrying more than one i would use rope or a ratchet strap to hold the boxes together and hold it by the rope or ratchet strap. the most i have carried was 7 pizza's and i bike them about 3km to school for lunch.
#5
Senior Member
Attachment 167584
Surely a more elegant solution exists. Anybody have any suggestions or personal experiences? Pictures would be awesome.
Surely a more elegant solution exists. Anybody have any suggestions or personal experiences? Pictures would be awesome.
But if you do pick up pizzas often and have a decent length ride then spending the $15 or so for a good insulated pizza delivery bag would probably be worthwhile.
#6
Banned
Join Date: Mar 2004
Location: Maryland
Posts: 5,155
Bikes: rockhopper, delta V, cannondale H300, Marin Mill Valley
Likes: 0
Liked 5 Times
in
5 Posts
I agree with prathmann, bungies should always run front to back, never side to side, but unless you have a very long rack or a very small pizza, the box will hang over the back and still be subject to forces that are likely to cause the box to fold.
A task best left to the professionals. Most pizza joints deliver. I know a guy who has carried 18 large pies without a rack. Six hanging from each grip and six on top of the handlebars. Best left to the professionals. Don't forget to tip!
I carried 18 pizzas once (from here, https://www.eatyourpizza.com/), but I have a trailer. I did not receive a tip. That equals 0% of the $381 dollars they spent on the pies. Never again. You want Pizza Paradiso, go get it yourself. Don't call me. End of rant.
A task best left to the professionals. Most pizza joints deliver. I know a guy who has carried 18 large pies without a rack. Six hanging from each grip and six on top of the handlebars. Best left to the professionals. Don't forget to tip!
I carried 18 pizzas once (from here, https://www.eatyourpizza.com/), but I have a trailer. I did not receive a tip. That equals 0% of the $381 dollars they spent on the pies. Never again. You want Pizza Paradiso, go get it yourself. Don't call me. End of rant.
#7
cowboy, steel horse, etc
Join Date: Sep 2008
Location: The hot spot.
Posts: 45,331
Bikes: everywhere
Liked 7,995 Times
in
4,256 Posts
Ouch! Poor pizza! Looks like longer bungees might be in order so that they're not under quite as much tension when holding a pie.
I do the plywood thing for picking up doughnuts. Two pieces of thin plywood with notches cut in the center of each side (so that the bungees stay in the notch. I put one below and one above the doughnut box. I don't bother mounting them to the rack.
Single piece of plywood below the pie would likely work for you.
I do the plywood thing for picking up doughnuts. Two pieces of thin plywood with notches cut in the center of each side (so that the bungees stay in the notch. I put one below and one above the doughnut box. I don't bother mounting them to the rack.
Single piece of plywood below the pie would likely work for you.
#8
Uber Goober
https://worksmancycles.com/shopsite_s.../indbikes.html
Scoll down near the bottom, there's a Low Gravity bike with pizza box.
Scoll down near the bottom, there's a Low Gravity bike with pizza box.
__________________
"be careful this rando stuff is addictive and dan's the 'pusher'."
"be careful this rando stuff is addictive and dan's the 'pusher'."
#10
Senior Member
Thread Starter
Join Date: Jan 2010
Location: Athens, GA
Posts: 133
Likes: 0
Liked 0 Times
in
0 Posts
Ouch! Poor pizza! Looks like longer bungees might be in order so that they're not under quite as much tension when holding a pie.
I do the plywood thing for picking up doughnuts. Two pieces of thin plywood with notches cut in the center of each side (so that the bungees stay in the notch. I put one below and one above the doughnut box. I don't bother mounting them to the rack.
Single piece of plywood below the pie would likely work for you.
I do the plywood thing for picking up doughnuts. Two pieces of thin plywood with notches cut in the center of each side (so that the bungees stay in the notch. I put one below and one above the doughnut box. I don't bother mounting them to the rack.
Single piece of plywood below the pie would likely work for you.
And just one long bungee works? Sounds like this might be a good way to go because I don't want anything permanent.
#11
Bike addict, dreamer
Join Date: Nov 2009
Location: Queens, New York
Posts: 5,165
Likes: 0
Liked 0 Times
in
0 Posts
I was thinking about somehow adding fold-out side platforms to my rack to support larger items. But I'm afraid my metal-working skills are insufficient for such a project. Unless I can find something that can be modified. It'd have to be black though.
#13
Member
Join Date: Aug 2009
Posts: 49
Likes: 0
Liked 0 Times
in
0 Posts
went and got a pizza tonight. here is how i get it home. four straps. first i put on the the two running side to side and they are tightened about as tight as they can be without squishing the box at all. the ones that run front to back are tightened unitl the box won't move.
i think all you would need to do to make this work on a regular rear rack is put a piece of plywood under the pizza box. wouldn't need to be as big as the pizza box, just some amount wider than the rack so it will help spread the load on the box.
![](https://bikeforums.net/attachment.php?attachmentid=167970)
![](https://bikeforums.net/attachment.php?attachmentid=167971)
![](https://bikeforums.net/attachment.php?attachmentid=167972)
i think all you would need to do to make this work on a regular rear rack is put a piece of plywood under the pizza box. wouldn't need to be as big as the pizza box, just some amount wider than the rack so it will help spread the load on the box.
#14
Senior Member
Thread Starter
Join Date: Jan 2010
Location: Athens, GA
Posts: 133
Likes: 0
Liked 0 Times
in
0 Posts
went and got a pizza tonight. here is how i get it home. four straps. first i put on the the two running side to side and they are tightened about as tight as they can be without squishing the box at all. the ones that run front to back are tightened unitl the box won't move.
i think all you would need to do to make this work on a regular rear rack is put a piece of plywood under the pizza box. wouldn't need to be as big as the pizza box, just some amount wider than the rack so it will help spread the load on the box.
![](https://bikeforums.net/attachment.php?attachmentid=167970)
![](https://bikeforums.net/attachment.php?attachmentid=167971)
![](https://bikeforums.net/attachment.php?attachmentid=167972)
![](https://bikeforums.net/attachment.php?attachmentid=167973)
i think all you would need to do to make this work on a regular rear rack is put a piece of plywood under the pizza box. wouldn't need to be as big as the pizza box, just some amount wider than the rack so it will help spread the load on the box.
#16
Member
Join Date: Aug 2009
Posts: 49
Likes: 0
Liked 0 Times
in
0 Posts
i used this stuff to line the windows on the south side of the house to help keep cool:
https://www.homedepot.com/Building-Ma...atalogId=10053
i have some left over, and i am going to use it to make an "envelope" to put the pizza box(es) in to keep them hot. i'll post a photo when i get done with it.
https://www.homedepot.com/Building-Ma...atalogId=10053
i have some left over, and i am going to use it to make an "envelope" to put the pizza box(es) in to keep them hot. i'll post a photo when i get done with it.