Road Morph pump broblem
#1
a77impala
Thread Starter
Road Morph pump broblem
Road morph bike pump.
I have this pump and yesterday when attempting to pump up a tube to find the puncture it didn’t work!
it had no pressure at all. I walked a mile and half to my car.
it appears the O ring won’t create any pressure. I went to local hardware store for new O ring.
the one like the original didn’t creat any pressure and the next larger wouldn’t go into the pump.
Does this pump require a special O ring and if so where do I get it?
I have this pump and yesterday when attempting to pump up a tube to find the puncture it didn’t work!
it had no pressure at all. I walked a mile and half to my car.
it appears the O ring won’t create any pressure. I went to local hardware store for new O ring.
the one like the original didn’t creat any pressure and the next larger wouldn’t go into the pump.
Does this pump require a special O ring and if so where do I get it?
#4
aged to perfection
Join Date: Jun 2009
Location: PacNW
Posts: 1,897
Bikes: Dinucci Allez 2.0, Richard Sachs, Alex Singer, Serotta, Masi GC, Raleigh Pro Mk.1, Hetchins, etc
Liked 1,317 Times
in
698 Posts
it's a topeak pump. I am not sure if parts are available but the O ring is certainly a failure point.
on ebay I see a "road morph repair kit" which has the replacement part but its $6.00 and "you don't want to pay that much"
personally I would buy a new pump. That one probably is not worth fixing
but what do I know ?
/markp
on ebay I see a "road morph repair kit" which has the replacement part but its $6.00 and "you don't want to pay that much"
personally I would buy a new pump. That one probably is not worth fixing
but what do I know ?
/markp
#5
Clark W. Griswold
Join Date: Mar 2014
Location: ,location, location
Posts: 14,072
Bikes: Foundry Chilkoot Ti W/Ultegra Di2, Salsa Timberjack Ti, Cinelli Mash Work RandoCross Fun Time Machine, 1x9 XT Parts Hybrid, Co-Motion Cascadia, Specialized Langster, Phil Wood Apple VeloXS Frame (w/DA 7400), R+M Supercharger2 Rohloff, Habanero Ti 26
Liked 4,272 Times
in
2,851 Posts
The Topeak Road Morph is a rebuildable pump generally they have rebuild kits for it and your local Topeak dealer may have the kit and can get you the part you need. I wouldn't ditch the pump and if you are doing that send it to me and I will take care of it.
#6
a77impala
Thread Starter
I like the pump, when it works. I put some oil on the O ring end, worked for a few minutes.
I’ll check with a bike shop next time I’m near one, see if they have parts.
I’m 180 miles from nearest good bike shop!
I’ll check with a bike shop next time I’m near one, see if they have parts.
I’m 180 miles from nearest good bike shop!
#7
Senior Member
Join Date: Dec 2005
Location: Cape Vincent, NY
Posts: 1,402
Bikes: Specialized Tarmac Expert, 2002 TREK 520, Schwinn Mesa WINTER BIKE, Huffy Rock Creek 29er, 1970s-era Ross ten speed. All my bikes are highly modified(except the Tarmac) yet functional, and generally look beat to ****. .
Liked 91 Times
in
54 Posts
Unfortunately, you might have a tough time finding the o-ring, most shops will sell you a new pump but don't stock the o-ring. You can buy one on-line but between the price and the shipping you'll probably just opt for a new pump. I have two of those pumps sitting in my garage with worn out o-rings.
#8
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Likes: 0
Liked 1,099 Times
in
745 Posts
Contact Topeak's customer service. They are very likely to send you a replacement o-ring (or perhaps a brand new pump) at no cost.
Likes For HillRider:
#9
Insane Bicycle Mechanic
Thanks for the reminder to oil the o-ring in my pumps. It’s been a while since I had a flat on the road and I know I’m tempting the Flat Gods by saying so.
__________________
Jeff Wills
Comcast nuked my web page. It will return soon..
Jeff Wills
Comcast nuked my web page. It will return soon..
#11
Senior Member
Join Date: Dec 2010
Location: northern Deep South
Posts: 9,006
Bikes: Fuji Touring, Novara Randonee
Liked 2,010 Times
in
1,257 Posts
Phil's Tenacious is my favorite because it's sitting at the front of my bench.
If you run into this problem again, you might be able to get home by trickling some water from your bottle into the pump. It probably won't get you up to full pressure, but it may seal the O-ring enough to get enough pressure a couple miles' ride home. But when that happened to me, I replaced the pump. It was 10-12 years old, so I got my money's worth out of it.
If you run into this problem again, you might be able to get home by trickling some water from your bottle into the pump. It probably won't get you up to full pressure, but it may seal the O-ring enough to get enough pressure a couple miles' ride home. But when that happened to me, I replaced the pump. It was 10-12 years old, so I got my money's worth out of it.
Likes For pdlamb:
#13
Senior Member
Join Date: Sep 2005
Location: Michigan
Posts: 3,713
Bikes: Trek 730 (quad), 720 & 830, Bike Friday NWT, Brompton M36R & M6R, Dahon HAT060 & HT060, ...
Liked 339 Times
in
254 Posts
#14
Senior Member
Join Date: Dec 2011
Location: NE Ohio
Posts: 2,601
Bikes: 1992 Serotta Colorado II,Co-Motion Speedster, Giant Escape Hybrid, 1977 Schwinn Super Le Tour
Likes: 0
Liked 112 Times
in
85 Posts
Had the same problem when we were touring on our tandem in Denmark. I took the pump apart and spit on the "o" ring! Worked until we got to a home center.
Now I do abit of maintenance on the pump before every tour.
Now I do abit of maintenance on the pump before every tour.
Likes For Tandem Tom:
#15
Senior Member
Join Date: Feb 2012
Location: Golden, CO and Tucson, AZ
Posts: 2,864
Bikes: 2012 Specialized Elite Disc, 1983 Trek 520
Liked 790 Times
in
445 Posts
I neglected mine once for a couple of years. (After I started using Gatorskin tires, flat frequency went way down.) So it didn't work when needed. It was full of grit from riding in rain, etc. I happened to be at the end of a desert ride and was out of water, didn't even have enough spit to clean it and make it work. I had to walk a couple of miles into Albuquerque. Now I clean it and check it after every ride in the rain, and do a complete tear-down service on it yearly. And I keep it inverted on the frame. (Someone on this forum puts some kind of condom over the handle.) It's a great pump, worth the extra attention.
Likes For Bike Gremlin:
#18
Mad bike riding scientist
Join Date: Nov 2004
Location: Denver, CO
Posts: 27,514
Bikes: Some silver ones, a red one, a black and orange one, and a few titanium ones
Liked 4,340 Times
in
2,435 Posts
Use something other than oil. You want something semi-solid that stays in place. Silicone grease, bearing grease, Vaseline, etc. would work better. As to the o-ring, you need to make sure you match the cross-section of the o-ring as well as the proper diameter.
__________________
Stuart Black
Plan Epsilon Around Lake Michigan in the era of Covid
Old School…When It Wasn’t Ancient bikepacking
Gold Fever Three days of dirt in Colorado
Pokin' around the Poconos A cold ride around Lake Erie
Dinosaurs in Colorado A mountain bike guide to the Purgatory Canyon dinosaur trackway
Solo Without Pie. The search for pie in the Midwest.
Picking the Scablands. Washington and Oregon, 2005. Pie and spiders on the Columbia River!
Stuart Black
Plan Epsilon Around Lake Michigan in the era of Covid
Old School…When It Wasn’t Ancient bikepacking
Gold Fever Three days of dirt in Colorado
Pokin' around the Poconos A cold ride around Lake Erie
Dinosaurs in Colorado A mountain bike guide to the Purgatory Canyon dinosaur trackway
Solo Without Pie. The search for pie in the Midwest.
Picking the Scablands. Washington and Oregon, 2005. Pie and spiders on the Columbia River!
Likes For cyccommute:
#20
Clark W. Griswold
Join Date: Mar 2014
Location: ,location, location
Posts: 14,072
Bikes: Foundry Chilkoot Ti W/Ultegra Di2, Salsa Timberjack Ti, Cinelli Mash Work RandoCross Fun Time Machine, 1x9 XT Parts Hybrid, Co-Motion Cascadia, Specialized Langster, Phil Wood Apple VeloXS Frame (w/DA 7400), R+M Supercharger2 Rohloff, Habanero Ti 26
Liked 4,272 Times
in
2,851 Posts
https://www.topeak.com/global/en/pro...6-ROAD-MORPH-G
https://www.topeak.com/global/en/pro...-TURBO-MORPH-G
https://www.topeak.com/global/en/pro...-MORPH-DIGITAL
https://www.topeak.com/global/en/pro...MOUNTAIN-MORPH
The Road Morph G and the Turbo Morph Digital have nearly the same hose length (minus a mm or two). The difference is the Gauge is part of the pump head which does change the overall length but the hose is nearly the same.
For me I like the Road Morph for high pressure stuff and my Turbo Morph actually lives in my travel tool case but have brought it out mountain biking and used it on rare occasion for other high volume stuff. I do like the Turbo Morph for it's easier to read gauge but that is not super important either way for a portable pump.
#21
Senior Member
Join Date: Sep 2004
Location: Chicago area
Posts: 2,580
Bikes: Airborne "Carpe Diem", Motobecane "Mirage", Trek 6000, Strida 2, Dahon "Helios XL", Dahon "Mu XL", Tern "Verge S11i"
Liked 596 Times
in
407 Posts
I also like the Road Morph... mine is so old I can't tell if it's a "G". IIRC, when I bought these (I have 2) the choice was between a "Road Morph" and "Mountain Morph", and I went with the former. It's almost like having a floor pump on the bike.
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/2000x1504/airborne_at_volo_bog_190602_cd8dc673f07db8e16c6800b6471ca502580a0361.jpg)
The Road Morph is attached to the seat tube.
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/2000x1504/airborne_at_volo_bog_190602_cd8dc673f07db8e16c6800b6471ca502580a0361.jpg)
The Road Morph is attached to the seat tube.
#22
Clark W. Griswold
Join Date: Mar 2014
Location: ,location, location
Posts: 14,072
Bikes: Foundry Chilkoot Ti W/Ultegra Di2, Salsa Timberjack Ti, Cinelli Mash Work RandoCross Fun Time Machine, 1x9 XT Parts Hybrid, Co-Motion Cascadia, Specialized Langster, Phil Wood Apple VeloXS Frame (w/DA 7400), R+M Supercharger2 Rohloff, Habanero Ti 26
Liked 4,272 Times
in
2,851 Posts
I also like the Road Morph... mine is so old I can't tell if it's a "G". IIRC, when I bought these (I have 2) the choice was between a "Road Morph" and "Mountain Morph", and I went with the former. It's almost like having a floor pump on the bike.
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/2000x1504/airborne_at_volo_bog_190602_cd8dc673f07db8e16c6800b6471ca502580a0361.jpg)
The Road Morph is attached to the seat tube.
![](https://cimg5.ibsrv.net/gimg/bikeforums.net-vbulletin/2000x1504/airborne_at_volo_bog_190602_cd8dc673f07db8e16c6800b6471ca502580a0361.jpg)
The Road Morph is attached to the seat tube.
#23
Senior Member
Join Date: Sep 2004
Location: Chicago area
Posts: 2,580
Bikes: Airborne "Carpe Diem", Motobecane "Mirage", Trek 6000, Strida 2, Dahon "Helios XL", Dahon "Mu XL", Tern "Verge S11i"
Liked 596 Times
in
407 Posts
Hahaha... that makes sense! They're *both* "G". The gauge is what makes it such a good product; you can watch it while operating the pump and not having to contort to see the pressure or maintain the seal on the valve stem.
Likes For sweeks:
#24
a77impala
Thread Starter
selection of metric O rings, bought the one closest to what I have.
It didn’t work, even with 30 weight oil applied to it. I have two other working pumps so it’s not that I have to use
this one.
#25
Just Pedaling
I went to local Runnings, they sell everything from fishing tackle to farm needs. They had a large
selection of metric O rings, bought the one closest to what I have.
It didn’t work, even with 30 weight oil applied to it. I have two other working pumps so it’s not that I have to use
this one.
selection of metric O rings, bought the one closest to what I have.
It didn’t work, even with 30 weight oil applied to it. I have two other working pumps so it’s not that I have to use
this one.