Park FT-4 instructions and rim puller ID
#1
Senior Member
Thread Starter
Park FT-4 instructions and rim puller ID
I recently purchased two of these Park FT-4 and wondering if anyone has the instructions for use.
Unfortunately I didn't win this rim puller but was curious what the model number might have been to satisfy my interest.
Unfortunately I didn't win this rim puller but was curious what the model number might have been to satisfy my interest.
#2
Senior Member
Thread Starter
While I'm at it the tool on the left is a BB facer BFS-1 without the cutter but I could not figure out what the one on the right was. Some kind of die holder?
Likes For bboy314:
Likes For John D:
#6
Senior Member
Join Date: May 2012
Location: Point Reyes Station, California
Posts: 4,631
Bikes: Indeed!
Liked 3,800 Times
in
1,197 Posts
Have you seen this drawing and write-up?
This gauge will allow you to check the fork blade alignment side-to-side. It will also allow you to check the front-to-back alignment of the two blades relative to each other. As far as I know it will not help you to figure out whether both blades have been pushed back as in a front end collision.
If you are interested in selling one of them I'm interested in buying.
Brent
This gauge will allow you to check the fork blade alignment side-to-side. It will also allow you to check the front-to-back alignment of the two blades relative to each other. As far as I know it will not help you to figure out whether both blades have been pushed back as in a front end collision.
If you are interested in selling one of them I'm interested in buying.
Brent
__________________
"I have a tendency to meander sometimes." B.G.
"I have a tendency to meander sometimes." B.G.