Thomson 26.0 Stems in Silver?
#1
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Columbus, Ohio
Posts: 445
Bikes: Serotta Colorado III Track (Renyolds Ouzo Pro Aero Fork, Dura-Ace to Mavic CXP-14 wheels, Sugino crank, Thomson and 3T the rest), Steelman Cyclocross (Campy Record 10, Deda Newton & Thomson stuff)
Likes: 0
Liked 0 Times
in
0 Posts
Thomson 26.0 Stems in Silver?
Anyone know why Thomson's 26mm bar clamp stems only come in black?
Do silver ones exist?
I'm just looking for a 90-100mm 1 1/8th 26mm Stem that's somewhere close to 17 degrees...but silver.
Do silver ones exist?
I'm just looking for a 90-100mm 1 1/8th 26mm Stem that's somewhere close to 17 degrees...but silver.
#4
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Columbus, Ohio
Posts: 445
Bikes: Serotta Colorado III Track (Renyolds Ouzo Pro Aero Fork, Dura-Ace to Mavic CXP-14 wheels, Sugino crank, Thomson and 3T the rest), Steelman Cyclocross (Campy Record 10, Deda Newton & Thomson stuff)
Likes: 0
Liked 0 Times
in
0 Posts
Is there a source for them somewhere online?
I'm looking for an elite, but the 26.0 sized ones only come in black as far as I've found:
https://www.lhthomson.com/elite_stem_sizes.asp
I'm not set on Thomson though, so I'm open to anything. I was looking at the Nitto UI-5GX (https://www.thebikebiz.com/product_p/...em-nitto05.htm) but I'd like something with a bit more of an angle so it's not awkwardly sticking up into the air, needlessly raising my bars. Should I just get a 25.4 stem and file down the clamp area a bit? Or, just not worry about it? I already have 26.0 Nitto bars, so I'd like to be able to use them.
I'm looking for an elite, but the 26.0 sized ones only come in black as far as I've found:
https://www.lhthomson.com/elite_stem_sizes.asp
I'm not set on Thomson though, so I'm open to anything. I was looking at the Nitto UI-5GX (https://www.thebikebiz.com/product_p/...em-nitto05.htm) but I'd like something with a bit more of an angle so it's not awkwardly sticking up into the air, needlessly raising my bars. Should I just get a 25.4 stem and file down the clamp area a bit? Or, just not worry about it? I already have 26.0 Nitto bars, so I'd like to be able to use them.
#7
Teaching Member
Join Date: Jun 2006
Location: State College, PA
Posts: 159
Likes: 0
Liked 0 Times
in
0 Posts
They make them, I just found some on ebay. Usually its only 5 degrees, but I know they make a -10. If you flip the 5 upside down, its a pretty subtle rise, so they wont needlessly raise your bars.
I dont know why finding a quality silver threadless stem is so difficult. just keep searching.
I dont know why finding a quality silver threadless stem is so difficult. just keep searching.