28h rear disc build, 3xDS/2xNDS
#1
Senior Member
Thread Starter
Join Date: Feb 2014
Location: SD
Posts: 2,745
Bikes: Handsome Fredward, Trek 1.1
Mentioned: 15 Post(s)
Tagged: 0 Thread(s)
Quoted: 481 Post(s)
Liked 131 Times
in
47 Posts
28h rear disc build, 3xDS/2xNDS
Looking to build a 2nd set of wheels for my CX bike. The first pair I built using the same brand of hub and rim, laced 32h 3x, resulted in 2mm of clearance between the NDS spokes and the rear disc caliper. This time the hub is 28h and I don't want to risk the NDS spokes rubbing the brake. Looking at lacing it 3x on the drive side and 2x on the non-drive side to ensure clearance. Thoughts?
#2
Senior Member
Join Date: Feb 2012
Location: Rochester, NY
Posts: 18,084
Bikes: Stewart S&S coupled sport tourer, Stewart Sunday light, Stewart Commuting, Stewart Touring, Co Motion Tandem, Stewart 3-Spd, Stewart Track, Fuji Finest, Mongoose Tomac ATB, GT Bravado ATB, JCP Folder, Stewart 650B ATB
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 4205 Post(s)
Liked 3,864 Times
in
2,312 Posts
I suspect the clearances differences will be rather small between 3x and 2x. Andy
__________________
AndrewRStewart
AndrewRStewart
Likes For Andrew R Stewart:
#3
Banned.
Join Date: Jun 2004
Location: Torrance, CA
Posts: 3,061
Bikes: Homebuilt steel
Mentioned: 18 Post(s)
Tagged: 0 Thread(s)
Quoted: 2193 Post(s)
Liked 425 Times
in
337 Posts
Your lacing pattern is fine. The NDS spoke tension will be about 50% of the drive side so reducing the crossing won't have any real affect on durability.
Likes For Nessism: