Stopping side flare on Brooks B-17
#1
Senior Member
Thread Starter
Stopping side flare on Brooks B-17
How do you keep the sides from flaring out on a Brooks B-17. I really do not want to punch holes and lace it. Doesn't seem like the comfort is affected, but when I am off the bike the flared sides look ugly to me. I have tightened it up slightly, but do not want to go that route and wreck the leather either.
Suggestions?
Suggestions?
#2
Junior Member
Join Date: Dec 2011
Posts: 18
Likes: 0
Liked 0 Times
in
0 Posts
Short of punching holes and lacing, I don't think there is anything you can do. Lacing it will certainly not ruin the saddle - lots of people have done it, and brooks even has a a model of the B17 (age leather I think?) that is laced from the factory. I even know one guy that punched holes and used plastic zip ties to keep his B17 from spreading.
#6
Senior Member
Thread Starter
Nothing alternative done. When I was riding today I actually paid attention to where the sides of the saddle are in relation to my thighs and realized that the flare is not going to rub my thighs, which is what I was afraid would happen. for now I am going to leave it alone and see what happens. Yep aesthetics are important to me, thats why I don't like modern bikes with severely sloping top tubes.I like the look of the 70's-80's bikes. If I am going to spend a few thousand I want it to look good as well as ride nice.
#7
Senior Member
If you punch and lace, i would put the holes up high. Otherwise eventually the saddle ovalizes and widens again.
Looks is a bad reason to lace a brooks, but lacing does yield a flatter, less hammocky top which is a big help to me.
#8
working on my sandal tan
Join Date: Aug 2011
Location: CID
Posts: 22,670
Bikes: 1991 Bianchi Eros, 1964 Armstrong, 1988 Diamondback Ascent, 1988 Bianchi Premio, 1987 Bianchi Sport SX, 1980s Raleigh mixte (hers), All-City Space Horse (hers)
Liked 2,600 Times
in
1,593 Posts
#9
Senior Member
How do you keep the sides from flaring out on a Brooks B-17. I really do not want to punch holes and lace it. Doesn't seem like the comfort is affected, but when I am off the bike the flared sides look ugly to me. I have tightened it up slightly, but do not want to go that route and wreck the leather either.
Suggestions?
Suggestions?
#11
Senior Member
I drilled and laced mine because the the flare was causing my thighs to chafe the sides of the saddle. I am seriously contemplating drilling out the holes on the saddle and cutting in between to make a poor-mans imperial. I want the "suspension" without the side flare.
#12
Senior Member
Thread Starter
Well for now the flare is not so bad as to cause chafing, so I will do nothing. If I start getting chaffed I guess I will swallow my aesthetic sense and drill and lace. In playing with it I can see how lacing my stiffen the saddle though.
#13
Senior Member
Don't drill, get a punch. You can drill leather but the holes are then torn instead of cleanly cut. A punch only costs eight dollars or something at a craft store.
#14
Junior Member
Join Date: Dec 2006
Location: SW Ohio
Posts: 83
Likes: 0
Liked 0 Times
in
0 Posts
I suspend my bike from the ceiling in my garage with rope around the saddle. This effectively keeps the sides of my B17 together as the rope comes together above and they do not flair after riding. So, try using a strong rubber band to wrap around the sides while not on the bike, which shuld accomplish the same thing.