What size end caps for Giant PR2 wheels
#1
Full Member
Thread Starter
What size end caps for Giant PR2 wheels
Picked up a Fuji Cross 1.3 as a spare bike…and I want to use my Giant PR2 wheels because they are tubeless. What size spacers do I need for the front wheel?
#2
Senior Member
Join Date: Jan 2010
Location: TC, MN
Posts: 39,520
Bikes: R3 Disc, Haanjo
Mentioned: 354 Post(s)
Tagged: 1 Thread(s)
Quoted: 20810 Post(s)
Liked 9,456 Times
in
4,672 Posts
Older and/or less expensive disc bikes may have come with quick release (QR) drop-outs, rather than the 12mm thru-axels that are common now. There are/were also some bikes, primarily gravel and cross, that came with forks took 15mm TAs. If your PR2s don't fit as-is, you'll need to see if Giant provides the necessary end caps to swap out to one of those two formats. If Giant doesn't, maybe the hub OEM does, but that'll take a little bit of leg work.
#3
Full Member
Thread Starter
My PR2 wheels are 12x100 thru axle(front). I used the spacer caps(or whatever they’re called) from them for another set of wheels I bought used. Now I want to use the PR2s for the Fuji and I don’t have the correct caps
#5
Senior Member
Join Date: Jan 2010
Location: TC, MN
Posts: 39,520
Bikes: R3 Disc, Haanjo
Mentioned: 354 Post(s)
Tagged: 1 Thread(s)
Quoted: 20810 Post(s)
Liked 9,456 Times
in
4,672 Posts
edit: that's if the Fuji fork also takes 12mm TAs, of course.
#6
Senior Member
Giant PR2 wheels have gone through several manufacturers, but Giant kept the same PR2 name. End caps for 1 set of PR2 wheels may not fit another.
Best to take your wheels to a bike shop that sells Giant and hope for the best. Good Luck.
Best to take your wheels to a bike shop that sells Giant and hope for the best. Good Luck.